
Mr Geoffrey Smith
129 followers
1 Video View·May 10, 2025
I made another tool case for work, this time to hold plumbing tools and fittings.
Well, it's been a minute, hasn't it?
Well, I went to Morocco, didn't I?
But I'm back now, and I've got a problem to fix with this.
You might recognize this if you've seen some of my videos
before, but this is an old aluminum case
that I used at work to carry manual tools, pliers, spanners,
hammer, that sort of thing.
But it got knackered.
So you might have seen the video where
I made a new version of it, plywood version,
chunky, and good.
And I've been using that ever since.
And this is wonderful.
And this, this poor thing, then became
with lots of lighter duties, so to say.
Pipe fittings, that sort of thing.
But man, it really is dying.
It's threatening to fall apart every time I pick it up.
If it had legs, it'd be on its last.
So the idea is to make a new one of these
and put this thing out to pasture.
So that's a piece of 18 mil ply that I'm going to use.
And these are my measurements.
So I'm going to sort of aim for roughly around there.
Yeah, roughly around there.
Right, I need four pieces.
No, I need two pieces at 50, two pieces at 40,
and two pieces of 15.
I'm most likely to get out the whole thing.
Yeah, let's get on.
I say some nonsense.
I don't need 15.
I need two pieces of 50, two pieces of 40,
and both of the pieces need to be 15 wide.
Still in my rocker there.
I've doubled it.
So when I do one cut, I'm actually doing two.
God, I'm getting all efficient, aren't I?
Dangerous, dangerous.
So that's me four pieces, my other sides.
Now, two of these need to be 50, and two of them needs to be 40.
I can't make that go wrong, can I?
Can I really?
No.
So that's going to be the sort of shape.
So now, corner clamps, glue, screws, palaver.
Ahem.
So it's done.
It's done.
And the very first thing that the three and a half people
that have probably watched this video are going to say is,
oh, it's not very tidy, is it?
Look.
You've got paint blobs.
Well, listen, as I've said many times before,
when I'm making something for my workshop, for my work,
I don't care about what it looks like.
I'm purely utilitarian about it.
It's got to be strong.
It's got to do what it's meant to do.
And that is it.
Let me show you an example.
That's the case I made a while back.
And it looks all tidy and everything, once I've finished.
But now, yeah, because it lives in the back of my van
and it gets bashed and crashed and mashed about.
So I'm not going to make fancy just to hold some bits and bobs.
So let's put some bits and bobs in, shall we?
Yeah, it looks a bit different now, doesn't it?
Close it up, and that is the job done.
And I'm very, very pleased with it.
I can just take my plumbing stuff in one go.
Of course, it's going to get mashed about in the back of the van,
as I told you before, but hey ho, that's the life of a box.
But I do have one more job.
I've got to sort him out.
