Chế Thuyền Thả Thính Từ Ống Nhựa PVC

Kênh Sáng Tạo .COM
4 Người theo dõi
1 Lượt xem video·15 thg 10, 2023
Hôm nay chúng ta sẽ cùng Chế Thuyền Thả Thính Từ Ống Nhựa PVC
Vật liệu cần đầy đủ để chế :
+ Ống PVC 48, Ốc vít, Xốp
+ 2* Motor 390 12v : https://goo.gl/otnQCK
+ 2* Motor giảm tốc 12RPM : https://goo.gl/D9HqvG
+ 2* Đầu đạn 4mm
+ Tay và mạch điều khiển 4 kênh
+ 2 * Chân vịt thuận nghịch
+ 2 * Khớp nối đồng 2,3 - 3mm
+ Pin 2S 7,4v, dây điện...
Kênh Sáng Tạo .COM Chúc các bạn thành công
Welcome to SangtaoChemcom channel
Today we will build a propeller boat
As I said before, today I will build from PVC plastic tubes
This place is quite a lot
You will need
I use tube 48
Here
Tube 48
You need 6 pieces
3
4
5
6
6 pieces
2 pieces of T
Tube 48
You just need 6-8 pieces
1 square tube 48
Tube 48
You just need 1 meter
Power supply
You will use a set of TX and X6
2S battery
7.4V
You use a big tube for a long time
2 motor speed reduction
12 revolutions per minute
This is from 6 to 12V
We use it to lift the propeller
2 bullets
4mm
4mm, not 3mm
2 motor speed reduction
390mm
This motor speed reduction is suitable
Because the propeller boat is slow
2 joint
2.3mm
3mm
2 screws
2.3mm
The frame of the boat is similar to the previous version
Now I'm going to do the bottom
To attach the motor
Like the previous version
Just bigger
You use this tube to cut 6 pieces
You use 2 screws
We attach the motor here
9.7mm, 9.8mm
You use 10mm
You use hot glue
This is like grease
To prevent water from entering
You do these 2 pieces
If the water deposits into the motor
It can't get into the boat
We put the duck legs in
This is the duck legs
We turn it like this
You use this tube
Cut two pieces
Cut 2 pieces
Now we will make the hole for the magnet
From 2 points
You need 4 screws
Cut 2 plastic tubes
48mm
So we finished 2 magnets
Now you will drill
Put it in here
When this rotates
We turn this
Pour the magnet
I will put it at the corner
You use 2 square corners
You break 2 faces
Like this
You put it in front
So it weighs the opposite
You use a needle
This needle
Use a screw to tighten it
So the mechanism is done
This rotates
You put the magnet here
This rotates
Now I will drill a hole
You use a plastic tube
Put the magnet in
Put a screw
There is still a hole
Drill
Put a screw
This rotates
Damn
Dance
Oh
Push forward
This side will turn
Turn clockwise
To run forward
This side will turn counterclockwise
Like this
That's it
Done
There are quite a lot of targets on both sides
You can fish
Now I'm going to run
Thanks for watching
