Ceramics Tutorial with Casting Technique

Sculpture Work
8 followers
30 Video Views·Feb 18, 2026
Today we're going to create
a ceramic piece using the
slip-casting technique employing a solid plaster mold
It can be obtained for example at a potter's workshop
Liquid clay which in this case
we use to pour into the mold
Copper oxide solution
a sponge virulana a
wooden base and wooden
rods brushes
clean water
We'll stir the liquid clay
thoroughly to ensure there
are no lumps as it settles slightly when not in use
Once the clay is
well mixed we'll fill
the mold but we'll go a little over
since the clay contracts as it begins to harden
We left it for about 10 to 15 minutes
Considering the thickness we want for the piece
Once we achieve the desired thickness
we’ll return all the excess back to the bowl
And we'll turn it upside
down until it dries We
place it on two wooden rods so air can circulate underneath
And we let him rest until unmolding
When the piece is moist but
already has the desired consistency
we remove all excess material
to facilitate demolding
But before removing it from the mold let's tidy it up
as much as possible to ensure the
piece comes out smooth and even
With a sponge and a little water
we've already removed one section
of the mold here and in this way we smooth out all the creases
what remained after demolding
Once we consider
that this is already fairly smooth
we remove it from the mold
and let it dry
approximately 72 hours
Here we can observe two differences
between one object and another The first
difference is that this bowl is wet
the one we just removed from the mold
And this one has already been dry for 72 hours
Another difference you can notice
small but still very real
It's the size What we mentioned earlier—that it shrinks
when it dries—is clearly visible here
when comparing the two objects
Once the object is dry we gently run
a damp sponge over it to tidy it up
The joints can be examined with a slight touch of
virulana gently without pressing hard as they may break
We'll keep refining it until the piece is perfect
We'll paint it using diluted copper oxide It's mixed with
water according to the desired
shade whether light or dark
Once the piece is prepared we place it in
the oven for the final baking which
is adjusted as time goes by
e power and temperature are increased until reaching
the desired 950 degrees at which
point the piece will be complete
We'll open the oven the following day
since the temperature takes time to drop
With this we have the finished
pieces and we begin with the oven
