How To UnJam a Dewalt Framing Nailgun

Dave Does Carpentry
1 follower
2 Video Views·Nov 19, 2026
If you've experinced a Jammed nails in the tip of your Dewalt Framing Nail Gun ( 18V XR Li-ion Brushless 2-Speed Framing Nailer) this video will show you how to effectively and easily get into the barrel to clear a jammed nail without breaking your nailer.
If this video helped you please leave a like on it and drop a comment below if you have any other queries or problems with your Dewalt Framing NailGun
Hey guys, how's it going? Today I'm going
to be showing you how to clear jam now out
of the new DEWALT 2-speed 18-volt brushless battery nail gun.
Alright, so hopefully for most of the jams of this gun,
all you have to do is flip it over to the top
and push, push across that lever
for the tool-free anti-jamming mechanism.
Try again then, it should free it up and not be jammed anymore,
but if you do have a nail wedge
in there you need to access inside the barrel to
and jam it. All you have to do, detach the battery,
take out any nails that you have and
On the magazine at the bottom down here,
you'll find yourself a little Allen key.
Make sure you don't lose that, because it'll
be extremely handy to have nearby,
because you might need to do this a few times.
Unloosen both of these Allen screws at the top here.
Just pull those out. They don't come off completely,
so don't worry about losing them.
And...
You can take the magazine out
and get into the actual barrel of your gun.
Once you're into the actual gun,
then you've got free range to get in there.
Hopefully any jammed nails will fall out. If the actual
punch is stuck, just get a nail punch, push it back down
and you've got free range to get clear of any broken or jammed nails
in your DEWALT nail gun. Once you've cleared any jammed nails
out of your gun, all you have to do is pivot the magazine back on.
Tighten the Allen screws back up, chuck your battery in,
chuck some nails in and you are good to go.
