Casting Carpenter Ant Tunnels in a Log with Resin (Cast #133)

Anthill Art
Anthill Art
20 followers
Nov 11, 2026

This log fell from a tree into my driveway after a storm and had a large area which was chewed away by carpenter ants. It was initially swarming with ants but due to the impact of the fall they were abandoning it. I put it to the side and when I checked it a few days later there were no ants around.

The first step was to seal any external holes so the resin wouldn’t leak. This was a major pain. I used resin and cloth rags which worked decently, but required further sealing with silicone. A reservoir for the resin pour was also needed, so I built up larger clumps of resin soaked cloth to make that.

It seemed possible that the resin would seep into the wood grain, so I first poured in silicone (Smooth-On Ecoflex 00-30). The silicone was poured in while shifting the log around to attempt to coat all of the tunnel walls. Then the bulk of the silicone was poured out of the log, hopefully leaving silicone-lined tunnels. This seemed to work as the final cast has minimal seepage into the wood. The silicone was dyed blue to make it stand out against the wood color and make it easier to see when chipping away at the wood. Resin doesn’t stick to silicone so it was easy to peel off the resin from the finished cast.

It's not shown in the video, but I repeatedly checked the seal by pouring water in and patching anywhere the water leaked.

After the silicone cured, a urethane resin (Smooth-On Smooth-Cast 327) was used to fill the tunnels.

Then I had to brainstorm on ideas to get the cast out of the wood and settled on leaving it outside to rot. It took around three years before it appeared soft and rotten enough to remove the wood. Even after three years, removing the wood took quite a bit of time and effort.

Finished cast is 7x8x14 inches.

0:00 Intro
0:08 Patching
0:29 Sealing with Silicone
0:59 Resin Pour
1:25 Leaving Out to Rot
1:36 Removing the Cast
2:01 Finished Cast