CLICK 'SHOW MORE' FOR FULL DESCRIPTION, TIME STAMPS AND ID NUMBERS Etrac: http://geni.us/2K7i NOTE: CTX3030 gives exactly the same ID numbers as Etrac. This video shows many of the coins you are likely to find and some we would all like to find when searching in the UK. I was using 4 tone ferrous audio and my deep settings as listed below the list of coins. Actual numbers may vary with soil conditions and depth but these air tests are more or less correct. Coins and screen ID are as follows (click on time to skip video to that point):
Farthings (1/4 penny) 04:47 Charles I rose farthing 12-17 Charles II farthing 08-47 George II farthing 11-36 George III farthing 12-44 George V farthing 12-30
1/2d (half penny) 05:24 George II 12-30 George III young 12-44 George III old 12-45 Victoria 12-32
1d & 2d (penny & two pence) 06:04 Victoria 11-39 George V 11-39 George VI 11-39 George III cartwheel 09-45 George III cartwheel two pence 01-39 George II maundy 2d (sterling silver) 12-28
3d (three pence) 06:42 Victoria (sterling silver) 12-40 George V (50% silver) 12-20 Elizabeth II 12-43
6d (sixpence) 07:06 Anne (sterling silver) 11-42 George II (sterling silver) 11-43 Victoria (sterling silver) 11-40 George VI (50% silver) 12-30
Shilling (12 pence) 07:36 George II (sterling silver) 12-46 Victoria (sterling silver) 11-46 George VI (50% silver) 12-38 Elizabeth II 11-10
Florin (2 shillings) 08:04 Victoria 'godless florin' (sterling silver) 07-46 Victoria 'gothic florin; (sterling silver) 09-47 Victoria double florin (sterling silver) 01-42 Edward VII (sterling silver) 07-47 George V (50% silver) 11-43 George VI 12-23
Half crown (2 shillings & 6d) 08:57 Young head Victoria (sterling silver) 01-46 Veiled head Victoria (sterling silver) 01-45 Edward VII (sterling silver) 02-46 George V (50% silver) 12-45 George VI 12-25
Crown (5 shillings) 09:40 Charles II (sterling silver) 01-44 George IV (sterling silver) 01-43 Young head Victoria 01-45 Jubilee head Victoria 01-42 Veiled head Victoria 01-42
Roman 10:21 Small bronze 12-18 Large bronze 12-46 Small silver 11-41
Hammered coins (silver) 10:46 Cut half penny 12-05 Edward I penny 12-12 Charles I half groat 12-26 Henry VIII half groat 12-15 Mary groat 12-26 James I groat 12-25 Elizabeth I 6d 12-30 James I shilling 11-41
Sovereign (22ct gold) 11:58 Elizabeth II half sovereign 12-18 Edward VII sovereign 12-30
Deep settings for hunting pasture: Discrimination = open screen Audio = Response normal, 4 tone ferrous Recovery deep = on Recovery fast = off Trash density = high Ground = difficult or neutral Sensitivity = manual as high as you can go without chatter. in difficult areas switch to auto +3 Swing slow and low for best results.
Hope you enjoyed this video - feel free to share it with anyone you think may appreciate it. Thanks for watching. Subscribe for more.
AI Generated·May contain errors
Hello there. In this video I'm going to be using the e-track.
I'm going to be doing air tests which
aren't perfect but they should give you a good idea
of where UK coinage hits on the e-track screen.
Now obviously I'm not using every UK coin
that was ever produced but I'm using a good
cross-section of things that we do find on a day-to-day basis
and also quite a few things
that we would very much like to find.
Now on the e-track we're basically talking about the Ferris line
which goes horizontally 1 to 40 and we're talking conductive,
that's the vertical lines, imaginary lines that is,
which go left to right numbered 1 to 50.
So if you get something that is reading, oh I don't know, say 1220,
which would be where a groat-sized hammered coin or gold ring
or possibly some of those awful ring pulls would hit,
that would hit pretty much in the middle.
So it would be 12 lines down, 20 lines across.
Now for the purpose of this test, I'm using 4-tone ferrous.
So everything above the 17 line will give either
a medium-high or a high tone.
Basically, all the targets are going
to give a high-ish tone of some sort.
I personally don't like conductive
because it means you've constantly got to be looking at the screen.
It is good in certain situations
when you're winking things out of very contaminated areas,
but for the type of hunting I do in pasture,
four-tone ferrous reigns supreme, so that's what I'm using.
Even if you yourself prefer conductive,
at least you'll be able to see the numbers.
So, for example, a small cut-half hammered coin
with four-tone ferrous would give a pretty high tone,
with multi-tones conductive audio would give a low grunt.
So, yes, the audio will be different if you use the machine
in conductive, but the numbers should hit the same.
What I'm going to do is list all the coins that I'm testing,
along with the numbers, in the video description on YouTube.
If I can, I'll put the times which they occur as well.
So say I'll split all of the,
I don't know, farthings and half pennies up.
I'll put that at, it might be 3 minutes 20 or something.
So if you click that in the video description,
it'll take you straight to the farthings and half pennies.
Likewise, the hammered coins might be at,
I don't know, 8 minutes 20 or something.
So find them in the video description.
Click 8 minutes 20 or whatever it happens to be.
The video will skip straight to that point.
Just one thing before I start the video,
please bear in mind that these are air tests.
I'm basically waving the coin over the coil at various speeds to see
what readings we get on the screen and what audio responses we get.
In the ground, it is generally a little bit different
and at depth you can get quite bouncy signals on the e-track.
But with the e-track, we're looking for consistent conductive readings.
That's the vertical one.
So you might get a bouncy up and down signal,
and if it spends two-thirds of its time
in the top half, it's worth a dig.
It'll still give you readings of something at great depth,
but it might be bouncy.
These air tests will be very accurate,
because there's nothing in the way of the coin and the coil.
Just bear that in mind.
Hopefully you'll find this video useful, and thanks for watching.
Well that's about your lot, I hope you've found that video useful.
Now even if you couldn't be bothered to watch
the whole video, and I don't blame you it
was quite a long one,
at least now you've got all those coins written down in the video
description along with their readings
and that should be a good resource for you.
Also in the video description I'll put
a full explanation of how I have the machine set
up for pasture hunting.
So I really just want to give you all
this information to enable you to get the most
out of your machine.
Thanks very much for watching,
I'll probably do one on various artefacts as well, and I
shall see you next time.
That's
not a
hammered
coin.
That's a hammered coin.
Get in there.