Watch this If check engine light on and Hold Flashing/replace camshaft position sensor on Chevrolet

Autos hacks
81 followers
AI Generated·May contain errors
Hello it's Salome. So today in the morning I started my car
and have check engine light on and the hold warning light flashing.
Since some of my subscribers got similar car and thought why
not show it here. It might help some of you to save some cash.
whenever you see a check engine light on it means we have a code
and we have to read it with OBD scanner
so the OBD scanner located under
the steering wheel we're gonna connect it to our phone with
OBD scanner app the app i'm using called Torque it's very simple
to use we're gonna go to gear
Clear icon, fault codes, and then show logged fault,
and the code is P0335, and scan
shaft position sensor.
So the camshaft sensor located here,
we have to remove the spark plug cover,
camshaft belt cover and the filter box. So we gonna need a ratchet
and 10 millimeter socket. Let's undo these four 10 millimeter bolts.
Alright the cover is off and here's the sensor.
We can only remove the wire
harness from here but the sensor bolted underneath
with two 10 millimeter bolts.
Next we need to undo this 12 millimeter bolt on this side and this 10
millimeter bolt on this side.
Use a flat screwdriver to loosen the throttle body hose
and then remove the hose.
We just gonna put the filter box here for now.
There are three 10mm bolts holding the cover we need to remove first.
And here's the last one located under the belt.
I had to use long 10mm socket for that.
We just need to push it out and pull it up like that.
And here is the camshaft sensor bolted with two 10mm bolts.
Let's remove the wire harness first and then the bolts.
I had to use a small universal joint for that,
otherwise it's hard to reach them.
Let's pull the old sensor out, here is the new sensor I got, I think it
was under 10 bucks, visually compare them, alright they are the same,
here is the right direction you need to install like that, center
the holes and then hand tight the bolts, alright new camshaft sensor on,
let's put the covers back, these next steps will be exactly
the reverse of how we removed the covers and the filter box,
this car has almost 100,000 on it and it's my second time replacing
this sensor, let me know if you had that problem too.
Alright we are almost done,
let's put the wire harness back and then the spark plug cover.
And the last thing we need to do, erase the code.
Put the key on ignition, we gonna clear the code on the app.
Go to the gear icon, fault codes, clear logged faults.
Alright if we scan for a code again, there is no more faulty code.
Let's remove the OBD scanner and start the engine.
No more check engine light and no more flashing hold.
Hope the video was helpful for those of you owning the same car.
I will be installing the oil catch can
for this car, stay tuned for that.
So that's it for this video,
if the video was helpful and learned something new,
like and subscribe if you haven't already
and I will see you in the next one.
Bye for now.
