Dual Robot Welding of a Large Pipe Shell | Two Six-Axis Robots + Roller Stand
AI Generated·May contain errors
Video Summary
AI GeneratedThis video demonstrates an automated welding solution for large diameter shells using two 6-axis robots. By utilizing a roller stand and pneumatic clamping, the system allows two robots to weld separate ring seams simultaneously from above, significantly increasing efficiency compared to manual welding.
Comments are disabled for this video.
Large diameter shells are built from sections, so one shell carries several ring seams.
Welding them by hand means climbing round the part and doing one seam at a time.
Here the shell lies on a roller stand, held at one end by a pneumatic clamping head,
with two 6-axis welding robots standing side by side behind it.
Each robot brings its torch over the top of the shell,
one on the seam at the end, the other on the ring seam in the middle.
The middle seam has been tack welded in place first.
Both torches strike their arcs together, so two seams are welded at once.
While welding, each torch holds its own position, and the arc keeps running.
Up close, both robots work from above, each with its own wire reel on the wrist.
For dual robot ring seams on a shell, check three things,
how the shell is located and clamped on the stand,
how the two robots' work zones are kept apart,
and how the start and stop points of the two seams are staggered.
Send us your part drawing and daily output,
and we will reply with a shell concept and cycle time estimate.

