How to Connect 100 LEDs using NE555 and 4017 Decade Counter ICs #electronics #ic555

Crazy Couple DIY
53 followers
187 Video Views·Sep 6, 2026
In this tutorial, learn how to build a flexible LED sequencing circuit using the NE555 timer IC as a clock generator and the 4017 decade counter to manage the light patterns. Discover how to chain multiple 4017 ICs to expand your design and control a larger array of LEDs, while also learning how to adjust the sequence speed by modifying component values like the timing capacitor.
AI Generated·May contain errors
The 555 timer IC operates as a clock oscillator or a clock generator. The signal from the 555 IC
clocks the 4017 decade counter. Output from pin number 3 of the 555 timer IC is given as an input
to pin number 14 of the 4017 IC. Whenever a pulse is received by the 4017 IC, the counter increments
the count and activates the corresponding output pin Q0 to Q9 causing a shift. This IC can count
up to 10. To know more about this IC, please check out my tutorial number 26. The link is in the
description below. Now to flash more than 10 LEDs, we need to connect a second decade counter to this
setup. The carry out pin, pin 12 of the first 4017 IC connects to the clock input pin, pin 14
of the second 4017 IC. The carry out pin goes from low to high when the counter of the first IC
reaches 10. By connecting this pin to the clock input of the second decade counter, we can count
numbers higher than 10. In my first setup, I am flashing the same 10 LEDs using the two decade
counters. The Q0 pin of the second IC is connected to a NPN transistor. A small input current at the
base of the transistor allows much higher current to flow between the collector and emitter. The Q1
of the second 4017 IC is connected to the reset pin, pin 15. By connecting Q1 to the reset pin,
we stop the second IC from counting further up and resetting itself. Now to add another lot of
10 LEDs, we just need to move the reset pin from Q1 to Q2 and connect the common cathode of the
second lot to pin Q1 via a transistor. The anodes connect to the first IC exactly the same way the
first lot of LEDs are connected. You can continue adding LEDs to the second IC just by moving the
reset pin to the next corresponding pin and connecting the anodes to the first IC. To
change the speed of the LEDs, go ahead and change the capacitor to a higher or lower value.
