We recently published an epic ride & explanation session of Graham Jarvis Hard Enduro Trainings at a spectacular sector. Here is his ride back from top in Episode 2. The video was filmed back in July 2020 during Graham Jarvis Signature Tours - Sea to Sky launch where he was given a stock TE250i. This section was pretty epic and brutal in every way. We were shocked when he said that he would give it a go even after we witnessed him doing a lot of crazy stuff.
AI Generated·May contain errors
Video Summary
AI Generated
This video provides a technical guide on navigating a motorcycle down a challenging, high-grip terrain. The instructor emphasizes the importance of precision, weight distribution, and the \"floating\" technique for the front wheel to overcome obstacles and maintain control while descending.
So, you've done the hard bit, Jarvis Sinked you to a sea to sky, now it's time for a bit
of fun.
It's a bit shallower than you thought, isn't it?
Yeah, I don't know, it's nice and warm though, isn't it?
It's lovely.
So, the second part of this technique, we've come up onto the top, now we've got to get
back down.
So, the first part was to turn around, quite difficult, big drop to the right there, so
a lot of shuffling around, I just took my time rolling backwards and forwards, get back
a bit off the edge, get the back wheel good, and then doing the bouncing technique, we've
done that basic one on the flat, we should be confident here.
Bit of a gap, you've got to lift it across onto there, just nice and steady, take your
time, it's easy to get hooked up with your tyres trying to turn.
Again, lots of grip coming down, leaning right back, just slow, slow, slow.
Coming down is actually the easy bit, you just need a bit of confidence.
The turns are the tricky bit, because it's so grippy, it can just tip you off, so you've
got to make sure you turn into it first, when I did the hop around, just made sure I got
a good compression, nice and positive, and always leaning that way a little bit, just
to be safe if you have a dab.
Probably could have carried the front wheel right across there, but I played safe a little
bit, dropped it in, front wheel, compress again, little lift onto it, hold it, little
blip of the throttle, lots of grip, lots of grip, you can trickle it through.
Always pressure in the back, just lean back on it, low revs, as soon as you, too many
revs and clutch out, it's like when it's slippery, you spin up, but this stuff, if you clutch
out, it's going to be out of your hands because there's so much grip, so just low revs, keep
it under control, weight the back end, big nasty little one for the foot rest.
It looks horrible, but it's a simple technique, again that little compression, float in the
front, that's the technique, just float in the front, it's not fast, you don't have to
gas it, you just have to have the front wheel in the air, and slip in the clutch, and just
let it drive up, make sure it's through again, I'm not trying to turn too early, if the front
wheel's up, I can always manoeuvre it, if you drop in, you're pulling it out, so onto
there, and then left foot down, nice and safe, drop it back in, get your position, the back
wheel's going to sort itself out there, I floated this one, stop there, get the front
wheel and just float it onto that one, if I tried to turn tight, I was into there, and
the front wheel was dropping in, so just a little lift onto that, again, line for the
front, line for the back wheel, we've done that in a basic way, row this little bit,
let the bike do the work, lots of grip, bit of a hole here, so lean it in, lean it in
early, if you're into that side, get your foot down to the left, float the front again,
it's all about floating the front wheel, lean it in, get your foot down, make sure it's
on the top, so this time, you could line it up there, but it's a bit of energy and time,
if you wasn't confident, make sure you're straight, but you can roll into it, take the
front wheel wide, so the back wheel just clears that hole, front wheel floating, back wheel
onto there, get it safe, watch out for that, lean it into the left as you go, again, pull
on the front, get the front wheel in the air, just helping it through, it's going to catch
on the footrest, lots of grip, it's easy to get the front wheel up, little pull, little
bit of clutch and throttle, you can roll through this next bit, slip in the clutch again, pretty
hot, like sweating just walking it, so if you start to feel too tight, you've got to
engage, if it's hindering your strength to do it, just have a rest and make sure of each
bit, otherwise it's going to be a vicious circle, you'll get more and more tired, it's
better to have a good hit at, just wait until you've got your breath back, cool down a little
bit, so this next bit, roll through, again, line for the front, line for the rear wheel,
coming in wide with the front, so you clear that, float the front wheel, you can get the
foot down again, the back wheel takes an inside line, loads of grip, again, the front
wheel in the air, pressure on the back, roll it through, these little gaps can be awkward,
so you've just got to roll the front through and then if you think it's going to hit, sometimes
you can compress with the rear, it's like a little stoppie, but just enough lift with
the rear wheel to clear the pegs, so it's just compressing a little bit, help it through
and then roll in and sort it out afterwards, roll it in, roll it in, so I'm going to say
it again, line for the front wheel, line for the rear, coming in, front wheel to the left,
I want the back wheel on there, so I'm going to float round wide with the front, so the
back wheel's just got enough to get on to there, drop in the front on this one, let
it roll out and then we're home and hopefully dry.