How to finish off a laminate planking floor edge: next to a sliding closet door

VideoJoeKnows
63 followers
2 Video Views·May 20, 2026
http://www.VideoJoeKnows.com How to finish off a laminate planking floor edge, next to sliding closet doors, involves using your brains a little. How close should you cut the laminate planking floor pieces to the sliding closet door threshold? "I can't just cut it tight?"......that would be a no. There's a few things to know when it comes time to finishing off your laminate floor planking, especially up against an existing threshold like a closet door unit. The finish project should look right & be right, since you don't want any surprises popping up, after you finish your laminate planking floor project. What's the big deal anyway? I'll let "joe" explain what the big deal is.
http://www.VideoJoeKnows.com
AI Generated·May contain errors
Let's talk about this for a minute. How did I figure out where to cut this? How much of a gap
between this and the edge of the threshold for my sliding glass closet door? Well, I had to go to
the store and I had to make a determination of what I was going to use. They've got different
types of things over there to finish off this wood flooring. And I looked at some of those pieces
and I couldn't get the right color and it was really super expensive. So I looked at another
area in the store where the carpeted area was. This is just a flat metal piece.
It goes on a transition from linoleum over to carpet or something like that
or two seams, whatever. And I found something that matched fairly close and this was way cheaper.
And so I decided I'm going to use this. So, you know, I kind of held it. I had to hold it up there
and make a determination where I was going to install this. Because remember,
once I put these nails in, I still from the nail over to the edge of my wood flooring,
I've got to have at least 5 sixteenths in case this flooring expands. So I can't,
I can't screw this down and nail it too close to this edge. So I had to kind of hold that up
there, make a determination exactly where I wanted it. And then I had to measure back and
cut this piece off. Okay, so that's how I did that. And now this piece is going to fit right
on in there. Okay, but look at the store and see what kind of trim you're going to install.
This piece of trim here cost me $14 or $15. The other stuff that didn't really match this,
but it comes, you know, a wood long piece and it's got different transition pieces that you
use with it. Some of them you don't use. That was like $35, you know, for a six foot piece.
And so I saved quite a bit of money just deciding to go with this.
And, uh, that's not to say you're always going to use something like this. Your trim may be
slightly different. So when you go to the hardware store, look at different products.
You may find one is better than something else, or one is cheaper than something else.
Don't always assume that there's only one way to do things. So check her out.
