Guitar Setup 1 Setting Neck Relief

TheGospelGuitarist
1 follower
Mar 31, 2026
How to set your guitar neck releif amount using the truss rod.
Truss Rod Adjustment Video:
http://youtu.be/onX5vR-HYek
CruzTools Guitar Tool Kit Review:
http://youtu.be/ICRPOLGQJrU
AI Generated·May contain errors
Hey, Gospel Guitarist here with an instructional video on how to set up your neck relief, which
is done by your truss rod.
So I'm basically going to do a little series of videos on the instructions that come with
the Cruise Tools Kit, so you can get a visual of what they're talking about.
The first thing you want to do is set up your guitar so that the headstock's not resting
on the tabletop, because that's going to cause your neck to bend and bow upward.
And we don't want that.
We want to get an accurate measurement.
So the first step is to set your guitar up like that.
I have some foam pads underneath it that are making sure my headstock is not touching the
Once you're satisfied with that, take a capo and install it on top of the first fret, not
behind the first fret, but right on top of the fret itself.
This is actually fairly simple to do.
The second step that you want to do is you want to hold the string down on the final
fret.
At the end of the fretboard.
And then you take your automobile 10,000th's gauge and see how you're doing.
For guitars, a good starting point, anyway, is 10,000.
It's going to be according to how hard you like to bang your guitar, are you a light
player, are you a heavy player, etc.
But for general starting purposes, you would take your gauge and insert it at the 8th fret
right between, you're measuring the distance between the fret, the top of the fret and
the bottom of the string.
So your string is making a straight line and you're going to use this to measure how high
that line is over the fretboard.
And after a while you can get to feel the, if it's just barely, you know mine's barely
barely touching the measurement, but it's perfect, I mean it's not, my gauge isn't sloppy
and I'm not, when you insert it under the string, it should not be lifting your string
up.
If you have to lift your string up to get it on there, underneath it, then you need
to go down to a thinner gauge and see what you're actually at.
And you're going to have to put more relief in the neck if you are in that condition.
So depending on your measurement, if the string is too close to the fret or even sitting on
the fret and you can't even get this thing under here, then you're going to want to take
off your truss rod cover and you're going to want to turn to the left as you're facing
the guitar this way, turn it to the left and put some bow into your guitar neck, okay,
because this string definitely should not be sitting on any frets.
And if you tap it, you can hear that it's not sitting right on the fret, okay, and that's
all you do.
You just kind of go through a couple of the gauges around the 10, 12, 9,000s, see where
you're at, but the starting point would be 10.
And to credit the setup on this brand new Joe Pass, it's absolutely perfect and plays
really well.
So that's all there is for setting up the neck relief.
That's how you measure it.
Measure it at the 8th fret.
I hope that was helpful to you.
I'll be releasing the next step in the setup shortly.
So thanks for watching.
Don't forget to subscribe and like and share the video.
