GK-3 Problem Identified

TheGospelGuitarist
1 follower
2 Video Views·Mar 30, 2026
This is a followup to my GR-55 Problem video. Turns out the problem is with the wiring of the GK-3 which I discuss in this video.
View the fix here: http://youtu.be/bF5pop8zNmM
Hey Gospel Guitars here with just a quick update on my
GR55 rolling synthesizer issue I've been having. It's not with the
synthesizer this is a GK3 problem. I have received the new MIDI cable
and it works fine and the old cable works fine.
What doesn't work fine however is this bad boy right here.
Now when I got this unit something in my mind told me
that's the wink link in this whole design. There's this little tiny cover
plate right here that never gets tight and it's already
been stripped out where your cable coming from the GK
controller runs into the pickup. Well there's like
six or seven wires in there and they're really small and tiny.
I've already taken this off the guitar and taken a look
and a lot of people are having problems with the wires inside here
breaking loose up of the solder joints. They're just
snapping. I read where one guy took it into the
shop had it repaired it was his fourth string
and then he took it home played it for a little while
or a couple days or so and then like the third or second string went out.
In my case it's the second pickup which is not engaging and how I found that out
was I took a little screwdriver here and I started touching the contact
points on the back and when I did that I figured out which
string went to which contact and whenever I pushed a little bit
just a little bit on the second string contact it would make contact
and work for only a couple seconds and then it would relax and break contact
again. So it's got a bad solder joint or the wires just barely
making contact inside there. So that's the bad problem with the design of these
units is that the this little cable restraint as they might want to call it
here is just junk. It's useless and even I was playing and you know
see it already fell off there. See it's very very poor design.
There's a cable holder on the pickup mount and I've always had that tucked
underneath there but still when you're strumming
and your your palm naturally rests right in this area
so you're just going to be wiggling that thing ever so slightly
day after day, week after week, month after month and then one of the wires is
going to let go. Maybe more than one wire. So
I'm thinking of beefing up this area. I still am under warranty
and I just if I take it to the shop and bring it home and in two weeks a
because of the design. So I'm thinking I need to do something to beef this up.
Maybe there's some way I can put a tie on here that'll
keep this wire from moving. I got to figure something out.
I'll probably make a video on that if I do it myself.
If I take it in I won't until the next time it breaks but I'm not going to take
it to the shop twice. It just needs to be addressed somehow
and if I take it to the shop they're just going to fix that one little wire.
He's not going to beef up the unit and it's going to be vulnerable
to breaking again. So is it a wasted trip for me to do it under warranty
or do I just fix it myself and screw the warranty?
So I'm not afraid of a soldering iron so I may just go ahead and repair this
myself knowing what the issue is. But now that you know what the issue is
don't always think it's going to be your midi cable or
deoxit. It could be a loose wire right on the pickup itself.
This seems to be extremely common and a lot of people
really don't like the design is what I have found out on
several forums. So just want to pass this along for a slight update
on the GK3 problem. So more on this issue later.
