Carvin Quad X Inside

TheGospelGuitarist
1 follower
Mar 30, 2026
Taking a look inside of a Carvin Quad X-Amp guitar preamp.
Hey Gospel Guitarist here. Just thought I'd give you a quick video on what the inside of the
Carbon Quad X amp looks like on the inside. I thought I'd open it up today and see what
kind of tubes are in it and let's take a closer look shall we. So here we can see on the inside
a line of nine 12AX7 tubes. I have pulled them out and already cleaned out the sockets and
everything. I've already powered up and played on the unit last night and I have to this point found
absolutely nothing wrong with any components. The tubes however are unmarked. A couple of them say
12AX7A in red letters but there's no branding on any of these tubes so I am thinking that they are
stock factory tubes from Carbon which back in 93 they might be early Sovtec's. Not sure. They were
also using groove tubes back then so these could be unmarked groove tubes. I'm not sure about that
either so anybody has any information on that go ahead and leave a comment if you have information
on these units from that era but as you can see there's a lot of stuff to these. As I move in
and pan down a little bit you can see there's a lot of parts and it uses full size pots
on the volumes and there's little holes in the sides where you can shoot some deoxit if you need
to. The owner that I bought it from last said that these little guys here were a little noisy
but before I powered it up I just decided I'd just play with these for a few minutes doing this and
I have not had any crackling noises whatsoever off of any of the pots on the system so
everything works flawless and if you're wondering what the inside of the quad X amp looks like
we have the power section over here and if I swing up and back you can see there's one big
long motherboard along the back to handle all those inputs and outputs. Of course you have your
entire row of tubes and then you have two motherboards. You've got this top motherboard
and then there's another board underneath it which is the preamp board that handles all the
other knobs. This whole row down here is going to be all full size pots along the bottom. You'd
have to take off the bottom cover to get to those and I did notice that if you did that this reverb
tank up here is going to go with it because it's attached to the bottom plate so if you do that
you might have to disconnect the reverb unit first. So everything works and I'm happy with
the unit. It sounds really great. If you have one of these let me know what you're using for tubes.
It's V1 starts on the left and works all the way up to V9 on the right so
please leave any comments if you're using one of these as to what you are using in yours and
I'll probably just keep trying different tubes throughout time and see if I notice differences
and what I'll come to like and I'll post a video on on that later on. So that's it for this video
and thanks for watching. Please subscribe for further updates on the unit and my new guitar rack setup.
