Ghost MIDI Hexpander Install Part 2 "The Markup"

TheGospelGuitarist
1 follower
Mar 29, 2026
Installing the Ghost MIDI Hexpander into my Schecter C1-E/A. Part 2.
okay gospel guitarist here with a continuation into part two
of the ghost midi install and i'm going to try to make these quick videos so won't be long ones
taped up where i'm going to drill the holes and marked them on the tape and i have another video
where i did the procedure for installing the switch i'm going to follow the same exact
procedure where you tape it up mark it and then this way the tape keeps the finish from breaking
up on you as a drill bit goes through but you want to do the drilling very slowly as well that'll
help so i have the two markings here with a shifted a little bit towards the tone knob because
i want to be able to get my pinky around that volume knob so i'm not making them perfectly
centered i want them offset just a little bit and when you get the instructions or download them in
pdf form it gives you a template for installing the the midi jack and so i have the blue tape
underneath to protect the finish again and then i taped and actually glued but the glue didn't take
the tape too well so i put tape too and then you will start drilling out the holes with the mounting
holes being drilled first and then secondly you would go in and drill the inner four holes because
the unit's actually square only the plug is round the actual there's a board with the plug as i'll
show you when i receive it later today so you have to actually cut a square hole into the body
which will be easier on this because it's a hollow body i watched a guy doing a video last
night just to see what i'm in store for and he was hacking up a les paul and he had a lot more
wood to go through but it dawned on me this morning that this is a semi hollow body and i only got
about a quarter inch of wood so it's going to be freestanding inside the guitar and it shouldn't
take me maybe more than 10 minutes to bore this out and be receiver ready so that's the markup for
the guitar i'm going to go ahead and keep this original plate here i'm not going to swap it out
like i talked about in my first video i think i'll just leave it alone due to install so that's all
the marking i need to do for this guitar it helped having two switches here already so i got my
measurements from here to boom over here so now i'm waiting for the truck to show up with the kit
and uh if you've never done this or you know not familiar with your measurements i'm pretty
familiar with this guitar so i know everything will fit but typically when you get the kit you'd
want to lay out the parts on your guitar before you start drilling holes you want to make sure
everything's going to fit and i already know everything will fit so i'm good to go i just need
to start hacking into my guitar okay see you in the next video part three we'll be drilling
probably do both of these in one video but i'm going to cut them short so you
don't have to sit there and watch me do everything so stand by more to come
