Guitar Cab Micing Tip

TheGospelGuitarist
1 follower
2 Video Views·Mar 28, 2026
Just some tips on micing up a guitar cab using two different types of mics for recording two guitar tones to use for blending and creating a nice guitar track.
Hey, Gospel Guitarist here. I'm starting to mess around in my recording studio again,
and I thought I'd try something a little different than your usual setup for recording
your guitar. Over here I have a Rode NT-1 condenser microphone. You can see it's not
positioned dead center. I have it slightly off centered towards the outside of the cone.
And then up here I have a Sennheiser 421 dynamic microphone
that's pretty much in the center between the cone center and the outer rim. It's about halfway.
You can use this as a stereo recording rig, but what I'm doing here is not technically a stereo
recording, but I want two different tones that I can blend in the recording. So I have a dynamic
sound for a more direct sound, and then I have a condenser really close micing another speaker
for a completely different, most likely a lot brighter tone. So once I get these recorded,
even though it looks like it's a left and a right track, this will be a centered track and this will
be a centered track, and then you can do whatever you want once you get the take. So if I wanted to
have a stereo recording, I could have a dynamic tone for the guitar in the left and a condenser
type tone in the right. You wouldn't probably want to go hard left and right on that recording,
but you'd want to bring them about 10 and 12, so it'll sound more full and natural.
The other thing you could do is have the dynamic track stand alone and your condenser track
standing alone, and have it up the center in the mix, and then mix the two microphones
for the sound that you're looking for for your guitar tone.
And you're not even thinking stereo at that point, you're just thinking what's the tone of the guitar.
So this option gives you some things to play with as far as you're mixing and blending a dynamic
and a condenser tones on your guitar rig. Now if I were just really wanting to do a stereo micing,
I could do either two condensers or two dynamics, and then you get the same sound,
but it would be a left and right recording. Where here this is totally different tones,
so you might not like that in a stereo. If you pan too far left and too far right on the two mics,
it may not sound as natural. So just a little recording tip I thought I'd pass on. I'll make
more videos here shortly as I continue to mess around in my studio. So if you found this setup
a little helpful, or if you've never done this before, give it a try. I think it's going to be
an extremely flexible thing to play around with, and finding the right guitar tones. So until next
time, have a good one. Don't forget to subscribe and like the video. Thanks a lot.
