PreSonus Studiolive 16.0.2 Channel Gain Controls

TheGospelGuitarist
1 follower
1 Video View·Mar 27, 2026
How to set your channel gain controls to achieve proper signal to noise ratio. How to engage the input meters to see the level of the inputs on channels.
Welcome to my series on the Presonus StudioLive 1602 digital mixer.
Okay let's talk a little bit about your gain coming into the unit. Now along the very top
of your mixer you're going to see a row of controls. There's one for each channel and
these are for your inputs coming in. So it could be a cassette deck or a microphone.
Whatever sources you need to plug into your channels. This is going to control how hot
that input is going to be. So like right now let's go back here and change this back to a
standard setting. We can see a normal fat channel where I do have a compressor on and I'm looking at
the mic I'm using right now. And so if I want to see how hot my input is I can go down to the bottom
of the board right here on the left side of your faders you've got your meter button. So you want
to push the top button and it will illuminate and then it says input on it and then all your meters
up here will change to level meters for your inputs on each channel. So what you're looking
at here is you don't want to see any red clipping. Up here at the top of each one of these meters is
a red led that will clip and you don't want that staying lit for any length of time whatsoever.
Digital clipping is a really horrible sound. It's just really bad. So you don't want to see that.
If it just flashes once in a while you're okay. But the general rule from I would like to follow
is similar to well the same as following things for a recording studio. You want in the digital
world like this you want to have things hovering right around where I'm at here around negative 6
to negative 12 db and these meters here are not really giving you a lot to go on. Now see I just
clipped that when I just went really loud and that's okay. It's not going to do much damage
even in a recording. But if you've seen that red light all the time I'm going to get on the mic
here like this and then it's just like hammering it. Now I'm backing off the mic to my normal
position and you want to have a nice strong signal so that your signal to noise ratio is good. So the
mic is going to be very strong. Right now I have a door leading out of my apartment building with a
highway like 50 feet from my front door and you can't hear it because the noise level of it is
so low compared to the input of my voice on the microphone. So you want to get that set up so
that you're not injecting a lot of noise into the system. So if you're lazy about it and you've got
16 inputs running a low level noise that you can hear they build up on top of each other. So you
want your microphones and inputs very strong and very hot. And then when it comes to
mixing it in the front of house that's what your faders are for so you can get the levels that you
need. But the inputs need to be as hot as you can get them without clipping so you get really good
sound out of whatever instrument or vocalist that you are recording or reproducing live. So that's
the input structure of the system. It comes in through this control here and then it shoots
straight into your 48 volt or your phase invert buttons and then it goes into your path channel.
So the manual doesn't even talk about input gain at all for your quick start so
that's why I'm doing this video.
