Banana Hobby 3 CH 50MM Vektor w/ Gyro RC EDF Jet
Jan 19, 2026
So there you have it, the Vector.
It's a really good little jet.
It's a three-cell, runs on a three-cell 1,400 or 1,500 milliamp back.
That's what I use.
Let's take a quick look in here.
Using a spectrum receiver.
It's got a 50 millimeter fan with a 4,900 kV motor.
It flies very well, actually.
It penetrates the wind well.
I'll put this together, some tips for you.
Make sure before you put the wing and the tail section on that you fire up the system.
Check the servos.
Make sure that the EDF is turning in the right direction.
If it's not, just switch one of the three wires.
Make sure you've got thrust out the back.
I put the little screen here.
For some of you that fly off of runways with small rocks,
this will prevent a rock or something getting up in there and tearing your fan out.
Make sure that your landing gear plates are glued in real good.
These were a little loose. I had to re-glue them.
I like to put a little clear tape across the servos here.
Just to make sure everything is where it's supposed to be.
As I said, I'm using 1,400 and 1,500 milliamp packs.
I only put a third of an ounce on the nose.
When it balances, it'll be about like this when you hold it with your fingers.
Slightly down, slightly nose down.
You've got yourself a real nice jet.
For what it is and the size of the jet, it's very stable.
Check out BananaHobby.com.
Vector, go vertical, baby!

