Metal Viking Shield Edge Reinforcement

Shield of Antiquity
8 followers
4 Video Views·Dec 23, 2025
After hundreds of training fights my trusty old viking shield which I made six years ago
is in need of repair again. I had previously put on a new edge strip of hide and additional shield
clamps but apparently the material was of a much lesser quality, very flimsy and it wore out much
faster than the original edge strip. You can see that the wood is exposed in places and if I do
not cover it up again the shield edge will quickly deteriorate. However removing all the edge clamps
and adding a new edge strip of hide is not a great prospect even though it would provide me
with the opportunity to finally add an edge strip of proper dimension because the few surviving
examples show that original edge strips were a lot narrower than the ones that I made so the width
of the edge strips I cut previously is too big, it's much too wide. Fortunately there is another
option. Thanks to the excellent research of Tomas Vlasati I became aware of a shield from a viking
burial in Norway which sports a unique form of edge reinforcement. The edge is covered by small
strips of copper sheet which are fixed to the board by means of shield clamps, iron shield
clamps that is. So along the shield edge you can alternatingly see shield clamps and little strips
of copper sheet. I figured that if I went for this option I could possibly push one end of a copper
edge fitting under an existing shield clamp and then fix the other end with a new clamp.
Unfortunately this did work indeed. So for the new edge fittings and additional clamps I initially
cut copper and brass sheet to size. Subsequently some of the pieces had to be hammered flat again
and the sharp edges had to be smoothened by sanding. Naturally I made the new shield clamps
exactly the same size as the previous ones and I also had to add the same kind of design,
this dotted decoration around the holes for the rivets. I provide an extensive step-by-step
tutorial on how exactly I make my shield clamps. You can find a link to this public post in the
video description. In order to coat the pieces I did not dip them into molten tin. Instead I
cheated a little and used a modern tin coating agent soldering paste. You need a brush to apply
the paste to the clamps and a heat gun to start the actual tinning process. Make sure that you
only do it in a well-ventilated room and be aware that you may have to repeat the process a couple
of times to achieve the desired results. I also tin coated the heads of the nails which I will use
to fix the clamps to the shield board which I can start doing as soon as I have fitted the copper
strips to the edge. Now this turned out to be more difficult in places than I had hoped for
but eventually it worked out. For final montage I place a clamp on the edge, I drill the two holes
for the nails, then I push them through and finally I clip each nail before riveting it
and the rest is effort. So here's the final result. I'm quite happy with it and content
and I'm looking forward to finding out how it holds up in fencing training.
I was open here, I don't know if you... No, I just made it really high.
Yeah, okay, so it was good because it felt like you had the opening.
