DMG MORI Robo2Go 2nd Generation Tutorial
Dec 22, 2025
My name is Dominik Dallmann I am presenting to you our Robo2Go
Here in front of a CTX Beta 800 TC
Our Robo2Go is our compact flexible automation system
The highlight of the system is the easy programming here directly on the machine controller
Here is a graphical interface that guides you through the entire setup process
We will now set up a component and start with the hardware definition
Here we set which clamping device is equipped on the machine
Which gripper is used which pallet is used and in front of which machine the Robo2Go is positioned
We will now just put on a test chuck here
And now it's visible here we always have a diagram on the right showing which measurements need to be entered
We have a collet chuck mounted on the machine Here we
just need a measurement which is 130 mm in this case
Then the clamping device is engaged and can be selected in the current configuration
Here is the current configuration as mentioned clamps grippers machine and pallet
These are the information needed here for now
Now I am going to start the process Here we set up the workpiece
I have already created an example
We need the raw material diameter workpiece length and also the workpiece weight both for the raw and finished part
Optionally the processing time can also be set so that the system later
calculates how much time the entire pre-assembled palette actually takes
When it is set up we go to the program editor Here
I also create a new test piece or a test procedure
We have our kit here and here is our actual program that we are creating together now
When we think about it we first pick up a workpiece with the robot taking it from the pallet
Then we open the machine door in this case we unload the counter-spindle and load the main spindle
Close the door start the processing and place the workpiece back down
With that the process is already fully programmed
We now only need to make some settings in more detail
These are also displayed graphically again
For example which gripper do we use when picking up the workpiece
Clamp finished part gripper Do we want to grip from the outside or the inside
With the standard package we can do both
We can also say here what clamping depth do we want
In this case 30 millimeters
What is the safety distance
These are the inputs you enter
This is repeated in a similar form throughout the other modules
Why are we opening the door here with the robot
This has the following advantage
You can continue to use your normal NC programs
You do not need to make any changes to the NC program
Whether with or without a robot it remains the same
The program is now set up
Now we just need to load the pallet with workpieces and then we can start
We are going to the Home area I have prepared it
All parts are temporarily set up here
But I will still show how easy it is to rearrange and configure
Here you select the workpiece and can now for example say you
equip individual compartments or an order quantity of 20 workpieces
In this case we have loaded the entire range with workpieces
That is set up once
Now the data is being sent to the robot and we are done
Here is a brief overview of the time calculated for the system to process the palette
I am now starting the system

