Making Beautiful Stackable Bowls with Simple, Repeatable Steps

History culture hero
16 followers
Nov 25, 2025
Today I'm making a set of breakfast bowls.
They need to be stackable.
I'm inspired by a design from the 70's.
And I'm going to break the making process down so I can easily repeat the design.
I'm using 600g of clay.
I'm using my favourite yellow speckle mid fire.
I'll start by centering the clay.
Once I've centered the clay, I'll flatten the clay to about 10cm.
I push down into the clay leaving about 15mm in the base.
And I open out into a curve for the base of the bowl.
I compress the clay in the base with a sponge.
Now I bring the walls up and out.
I compress the rim.
And I'm going to straighten the side of the bowl.
I'm using a rib for this.
I'm holding the rib in my right hand and gently pressing the clay into the rib with my left.
Now that I have the basic shape, I add a swirl to the interior.
I measure and make sure the diameter is 16cm.
And now I can wire through.
I set aside to dry and then I make some more.
I dry to leather hard before trimming.
So my pieces have dried to leather hard and I'm ready to trim a foot ring.
I've left a little extra clay in the foot to trim.
So I upend and center my bowl.
And I fasten with lugs of clay.
I measure out the foot ring.
And then I mark the inner and outer line of the foot ring.
And then I trim around the outside.
I'm creating the outer shape of the foot ring.
And I define the change of direction where the foot ring meets the bowl.
And now I trim away the clay on the inside of the foot ring.
Starting in the center, I trim ridges into the clay.
And then I trim these ridges away.
This is a great way to control the trimming if your tool is chattering or digging into
the clay.
I check to make sure there's enough clay to trim.
And then I repeat the process until I'm happy with the foot ring.
And I smooth the clay with a rib.
I like to get the finish of my pots right at this stage so sanding becomes unnecessary.
If you haven't already done so, why not subscribe to our channel and like and comment below.
And I use a stamp to add my potter's mark.
So I can set aside to dry fully.
And now I bisque fire.
After the bisque fire, I can glaze.
This clay looks quite pink after the first firing.
I'm glazing in two parts.
I'm pouring a white liner glaze on the inside.
My liner glaze is a glossy white opaque glaze.
It's a very functional glaze.
And I'm dipping the outside in a slightly translucent matte glaze.
Notice I'm using magnets here to hold the pot as I glaze the outside.
I've made a handy how-to video as to how to use magnets in this way.
This is a pretty tidy way to glaze and there's no cleaning of bases.
Once glazed, I glaze fire.
The bowls stack.
If you'd like my notes with measurements for this project, follow the link below and I'll
email them to you.
If you're after more bowls, check out my signature pasta bowls.
And don't forget our Tufts Studio pottery calendar.
It makes a great gift for any potter.
And as always, happy potting.
