(الجزء الثاني) تجميع محرك مرسيدس cdi 313(Teil Zwei) Mercedes CDI 313 Motorbaugruppe #KasemAutoservice

One. As usual, guys. All the new collars come with the paper. And we're going to tighten the collars as it's written here in the dimensions. Okay, guys? Watch the video. As usual, guys. We've reached the last stage of tightening the collars. As usual, and as I do in every video, I explain it to him so that he can remember it. We'll get the wrench as usual. Look, here it's written the system of this car, which is... 20 Nm tightened. Then 60 Nm tightened. Okay? It's written here. Then 90 degrees tightened. We'll let the collar rest for 15 minutes, and then 90 degrees tightened again. Okay? Why is this model 90 degrees? Because the collar is short. If the collar was long, they would have removed the 90 degrees and put... They would have put 180 degrees. Okay, guys? So we're working on the short side. These dimensions will be for all the CDI engines. Look here, it's written. It will be for the 208, the 211, the 213, the 308. All the engines will be for the 313, which is for the 315 engine. These dimensions here, for the collar, will be for all these Mercedes cars. So that you know all the engines that are working on them. So now we're going to tighten. We'll start with 20 Nm. And step by step. Let's start with 20 Nm. We'll get a small wrench and tighten it. Okay, guys? Of course, we'll get a small wrench. We'll measure 20 Nm. We'll tighten it. It's easy. We'll get... Here, where's the first one? This side. This is the first one. Okay? We'll start with the first, second, third, fourth, fifth, sixth, seventh, eighth, ninth, tenth. Okay, guys? Let's see. Now, one. Two. Three. Four. Five. Six. Seven. Eight. We'll get nine here. Ten. Okay. Now, we'll go back to the back. The back says here, it's written, we finished 20 Nm. What's left is 60 Nm. Okay? We'll tighten 60 Nm. We'll get a big wrench. Of course, I put 60 Nm here, as you can see. We'll start from the beginning. I'll put a knot here. I'll put 60 Nm. One. Two. Three. Five. Two. Now, we'll get here. Here, we finished. We finished 60 Nm. Here, it's written 90 degrees. Okay? Now, we'll tighten 90 degrees. I'll explain to you what 90 means. Okay? Let's go. Now, you all know 90 degrees, right? You know 90 degrees, which is a quarter turn. Okay? I don't do many turns. Here. Okay? Okay. One. Two. Three. Four. Five. Six. Seven. Okay? One. Two. Now, the last one. Eight. Of course, dear viewers, now we have finished tightening the bolt. The original bolt from the factory. Eight bolts. Now, we have finished this part. The second part. In the third part, I'll put 100 Nm and the spare parts. So, it won't be a long video. God bless you all.