10 Ways MotoGP Racers MASTER the Corners

Speed Racing
166 followers
2 Video Views·Oct 30, 2025
How do MotoGP racers master the corners? Why do they blip the rear brake at the same time as shifting down? How come they adapt their body position to the corner speed?
You must have seen Mark Marquez do this. And a lot of MotoGP racers do this.
And definitely this. But what are they actually doing? And why? Here are 10 ways in which MotoGP
racers master the corners. Number 1. Stand on top of the pegs. A lot of riders have probably
heard about the technique weigh the peg. And specifically weighing the outside peg on corner
exits for increased grip. Often times it is described as pushing down on the peg. But I
think this description is a bit misleading. What top level riders do is basically float in the
saddle. Meaning they are standing on top of the pegs and just gracing the saddle with their butt.
What this does is allow the bike to move more independently from the rider which allows the
suspension to work optimally. It also enables the riders legs to be a part of the suspension system.
A simple way to think about it is the way dirt bike riders stand up to allow the bike to move
around below them and let their legs be a part of the suspension. MotoGP riders are doing the
same thing but it's not as obvious. Number 2. Body position follows corner speed. In slower
corners MotoGP riders push their body as far to the inside of the corner as possible in order to
shift the combined center of gravity of them and the bike as far in as possible. This reduces the
lean angle of the motorcycle. It also causes an aerodynamic jawing moment that helps rounding
the turn. But in some really fast corners the aerodynamic drag can actually slow the riders
down so you see the riders adapt their upper body position after the corner speed. In some really
fast corners they look almost crossed up with their upper body centered on the bike. Number 3.
Smooth vision. Most riders have heard that you should look where you want to go and that you
should be looking far ahead. MotoGP racers go well beyond this. Racers use reference points in order
to engage the brakes at the right time, turn in, apex and exit. The way a racer transitions between
focusing on these reference points is very important. MotoGP riders transition where they
look in a very smooth way which helps with consistency and also keeping calm and collected.
So they look at the brake point, transition smoothly to look at the turn in, apex and exit,
all in one flow. Number 4. Blip the rear brake for stability. The rear brake can be used to
stabilize the bike at slow speeds and the same is true for high speeds. Just when the rider releases
the throttle and transitions to front brake and shifting down, many MotoGP riders also blip the
rear brake briefly. This has two effects. The first is that it stabilizes the bike and the second is
that it facilitates the transition to engine brake that is engaged after having shifted down. Number
5. Reduce engine brake at the end of the race. You have probably seen the buttons that are on
handlebars of the bikes. One of these buttons controls the amount of engine brake that is
applied to the rear wheel. At the end of races, the rear tyre will start to wear out and thus
provide less grip. When braking really hard, load is transferred forward which makes the rear wheel
light and can cause it to come out into a slide. This can be used deliberately to point the
motorcycle towards the exit and thus go through the corner faster. But too much sliding can also
be a disadvantage as it destabilizes the bike and forces the rider to settle the bike down before
properly turning in. So at the end of races, when the rear tyre starts getting worn out,
racers will reduce the amount of engine brake applied to the rear wheel so that it doesn't
slide too much when braking. Number 6. Adapt riding style to tyres. If you are really into
MotoGP, you often hear riders talk about the tyres. This is because the way they are constructed
influence the riding style which will produce the fastest lap times. The tyre's carcass stiffness
has a big influence on how hard the rider can be on the brakes, how much grip they have during
extreme lean angles and how hard they can accelerate on the exit. A stiff carcass tyre
allows for continuous high cornering loads suited for a rounded off progressive cornering style and
line. Softer carcass tyres that flexes a lot under load are suitable for a squared off V-line with a
short amount of time leaning over and aggressive opening of the throttle on the exit. Number 7.
Brake with slight lean angle. Remember we talked about carcass design and how it affects riding
style. What can a pro rider do if the carcass is really stiff and thus does not deform enough
when braking in a straight line? They can brake really hard with a small degree of lean angle to
force the tyre to deform and thus maximize the contact patch. You often see Mark Marquez using
this style of braking to get every bit of performance out of tyres. Kinda crazy huh?
Number 8. Clear mind. Have you ever heard racers talk about what they are thinking about while
racing? Most of them report that they are thinking about things like what they are having
for dinner tonight and not about the race. This is because the skills they are using are stored
in what is called procedural memory. Procedural memories are unconsciously recalled, in other
words, doesn't require consciously thinking about the task at hand. This is what we use when we for
instance ride bicycles. We do not have to actively think about what we are doing when riding the
bicycle. We do it automatically. It takes deliberate practice and tons of repetition to store a skill
in procedural memory. And that is how MotoGP riders acquire their almost inhuman-like abilities.
Some researchers believe that the best athletes and musicians excel because of their superior
ability to form procedural memories. Number 9. Push their elbow into the corners. The modern
racing style you see MotoGP riders use is to push their upper body into the corner to a great extent,
which as you know is to reduce the lean angle of the motorcycle as much as possible. To get the
upper body into the corner properly, the riders push their elbows in, and when leaning far enough,
the riders drag their elbow against the tarmac. Number 10. Use the rear brake on the exit. In
order to keep the front end down when accelerating out of corners, some riders still drag the rear
brake on the exit. Dragging the rear brake just a little bit settles the bike down. The winglets
you see on modern MotoGP bikes helps with this phase of cornering to keep the front end down,
and will probably render using the rear brake on the exit obsolete one day.
Remember to subscribe to my channel. There's always something new to learn.
