Icheon Ceramics: The Process of Making Icheon Traditional Ceramics

Ceramic Art Studio
35 followers
2 Video Views·Aug 18, 2025
Pottery is a comprehensive art form.
You have to know the process of making a shape,
sculpting and engraving,
and even sculpting,
to make a proper pottery.
You have to have a good balance from the beginning to the end
to make a perfect pottery.
This is the process of enlarging the shape.
Put strength at the end of your right hand and slowly go down to the center.
In this state, you start to make a boat.
You can widen the boat and raise it little by little.
You've reached the point where you've raised the bow of the pottery.
You have to hold the bow of the pottery well.
Now, we've made a boat that we can pierce a hole in.
I made a boat, and now I'm going to make a bow that goes in it.
This is the order in which the bow is made.
With enough strength to keep the balance,
you go down with the strength you can handle.
I'm going to make a boat while maintaining the center.
The object to be inserted inside is made 4 to 5 cm thick.
I'm going to use a belt knife or a thread to separate it.
I showed you how to make a two-way, four-way, and four-way.
In order to shape, the condition of the object is very important.
In a place where the wind does not come in,
Dry it so that the shape of the object can be maintained as it is.
I'm going to make a four-way, four-way, and four-way.
First, I'm going to cut the soil that's attached to the bottom of the pot.
The way I do it is to make a hole in the bottom.
I'll show you the process of joining.
I'll trim the outer diameter.
This is a dull sound.
This is a thumping sound.
This is the sound of a drum.
This is the end of the cutting process.
I'm going to put a pot in here.
I'm going to cut it like this and put it in the center.
I'm going to scrape this part a little bit.
I'm going to paint it so that the soil doesn't dry out.
I'm going to cut it like this and match it.
If you want to make the inner diameter and the outer diameter one,
I painted the inner diameter with water to make it stretch and dry.
If you tap it, spread it out little by little, and attach it like this,
It becomes a work of art.
This is how two bowls become one.
After painting the water, I think it's most common sense to make a hole in the front of the pot.
Even if the air passes through the vinyl like this,
It's better to wrap the vinyl perfectly so that it doesn't dry out any more.
Before I start painting, I'll draw a picture first.
I'll paint it after I open the pot.
I'm going to draw three circles and I'm going to do it under the line.
As it goes down to the bottom, the surface widens, so it widens the gap between the compasses.
This pattern is now in the shape of a seven-step.
I'm going to make a hole in the middle.
The force of the knife is very important because it is hard to scratch when working.
If you give it a little more force, it can pass.
That's why you have to move the knife inside the border.
Each and every process is a delicate process.
So you have to be good at cutting to reduce the amount of fire and make it pretty.
This is how it took about five hours to finish the work.
The next step is to clean the water and attach the flower pot.
I'll clean up the slippery part while I'm painting.
If you put a little bit of water on it, it'll stick well and it won't smell like fire.
If you don't do this quickly, the flower pot will fall off when it's dry.
Now, we're done with the two-sided flower pot.
