Hahow - 手作永生花玻璃罩│線上課程

FLOWER Gift
79 followers
#AteliePaloya #Handtied Bouquet #韓式花束包裝 手綁花束
Comments are disabled for this video.
Hello everyone, I'm Irene.
Today we are going to make a glass photo of the eternal flower.
There are the materials we need to make this work.
First of all, we need to prepare 10 kinds of flowers.
We need to prepare the tools.
Next, we need to prepare the tools.
There are four steps.
The first step is to cut the sponge.
The second step is to stick the sponge on the base of the glass photo.
The third step is to deal with the flowers.
The fourth step is to put the flowers on the sponge.
That's it.
First of all, we need to cut the sponge.
Cut the sponge into the right size.
The size of the sponge is determined by the area of the flower.
It won't exceed this line.
The reason is that if the flower exceeds this area,
the flower will stick on the glass photo.
The whole thing will be ugly.
Then the four corners of the edge should be flattened.
In this way, it will be easier to insert the flowers later.
Cut the original square sponge into an octagonal shape.
You can continue to correct it during the process.
If the flower exceeds this line,
it means that the sponge is too big.
Next, we need to stick the hot melt glue on the bottom of the sponge.
Apply the whole sponge.
Then stick the sponge on the base.
The middle should be a little bit back.
Because the main flowers will be placed in the front.
Next, we need to cut the wire.
Pass the wire through the center of the gold.
Then make a U-shape.
It doesn't matter if the length of the wire is short or long.
Because it will be trimmed later.
Next, we need to use the hot melt glue to stick the flowers and the wire together.
When using it, we need to pull the head of the hot melt glue first.
In this way, our hot melt glue will be sticky.
Start to wrap the hot melt glue.
Keep wrapping the hot melt glue.
After wrapping the wire and the wire together,
we can cut off the hot melt glue.
Now, we need to trim the wire.
The width of the wire is the width of the sponge.
It doesn't exceed the width of the glass.
What does it mean?
It means that if I want to stick the flowers on the top,
if the wire is too long,
the flowers will touch the top of the glass.
Do you remember?
When I was sticking the sponge,
I left some space in the front.
The reason is that when I stick the main flowers,
I will tilt slightly forward to show the flowers.
When I stick the main flowers,
I will stick it in the middle.
Because this point is the farthest from the glass.
My main flower is the largest flower,
so it needs more space.
When I stick the flowers,
I need to hold the root of the wire.
In this way, the flowers won't break when I stick them.
Next, we put the other flowers on the wire.
Use the hot melt glue to glue them together.
