雷克斯講航空歷史 二戰日本海軍艦載戰鬥機 九六式艦載戰鬥機發展簡史
王者风范
22粉絲
29 次觀看·2025年11月13日
The Navy Type 96, also known as the Mitsubishi K-14, and known more commonly in the West as the A5M Claude, was a Japanese carrier fighter built in the mid-1930s.
It was the product of a modernization program to reduce Japan's dependence on foreign equipment, and it would become the world's first monoplane carrier fighter to enter service.
In February 1934, the aviation headquarters for the Imperial Japanese Navy issued a new specification for a single-seat fighter.
The document, known as Specification 9-Xi, did not specify that it should be a carrier-borne fighter, just that it should be a fighter.
Because of this, the 9-Xi specification only quoted the performance requirements.
The new fighter must 1. Have a maximum speed of 350kmh at 3,000m
2. Climb to 5,000m in 6.5 minutes
3. Have a wingspan and length not exceeding 11m and 8m respectively
4. It must have an armament of two 7.7mm machine guns
Under the direction of Jiro Horikoshi, Mitsubishi's team began work on a new prototype to meet these requirements.
The prototype, soon to be designated the Ka-14, was built around a light-alloy monocoque with a flush-riveted aluminium-stressed skin.
Special attention was paid to aerodynamics and streamlining.
A thin wing profile was selected, the fuselage was given as small a cross-section as possible, and although a fixed undercarriage was used to save weight, it was covered by streamlined fairings.
The Ka-14 was powered by a Nakajima Kotobuki 9-cylinder radial engine.
It featured a reduction gear and was rated at 550hp for take-off and 600hp at cruising altitude.
It was selected over Mitsubishi's own engine, the A-4, as it was lighter without suffering any loss to performance or endurance.
The most recognisable feature of the Ka-14 was of course the elliptical inverted gull wing, which when viewed from head-on can be compared to a W in shape.
In the case of the Ka-14, this wing shape was chosen as it was used in a previous specification to improve cockpit visibility during landing.
However, early in the prototype's development, there were already concerns about its effectiveness.
There were reasons to believe that turbulent airflow would be generated by the anhedral-dihedral transition, which would then affect the overall flight characteristics of the plane.
Deciding to err on the side of caution, a second prototype, upon which construction had already begun, was modified to be completed with a standard wing so that the two models could be compared in the trials.
Eleven months after the 9C specification was issued, the first Ka-14 prototype was completed in January of 1935.
It flew for the first time on February 14th, flown by Mitsubishi test pilot Kojima.
The take-off weight of the Ka-14 was 1,373kg, resulting in a wing loading of 77.2kg per square metre.
This was considered rather high by Japanese standards, who valued lightness and manoeuvrability.
However, that being said, it was still significantly better than some other aircraft that were making their first appearance.
For example, the first prototype BF-109, that took off four months after the Ka-14, had a much higher wing loading of 117kg per square metre.
The flight trials of the first prototype not only exceeded the expectations of the design team, but they exceeded those of the 9C specification itself.
During further trials, a maximum speed of 444kmh was achieved at an altitude of 3,200m, eclipsing the performance of any other aircraft currently in the Japanese naval inventory.
Despite the success, there were still a couple of concerns raised by the test pilot.
The Ka-14 suffered longitudinal oscillations at high angles of attack, and the plane had a nasty tendency of trying to drop a wing during landing.
Wing dropping on an airfield could be inconvenient and sometimes dangerous, depending on the speeds involved.
But wing dropping on approach for a carrier landing was a different level of risk altogether.
And for this reason, it was hoped that the second Ka-14, the one with the straight wings, would perform even better.
At a late stage of construction, it was decided to add flaps to the centre section of this prototype as a result of the aforementioned landing issues.
The wing design also incorporated a change that expanded laminar flow over the wing tip, which was hoped to improve stability at high angles of attack.
Problems with the reduction gear on the Kotobuki 5 engine were solved by replacing it with the direct-drive Kotobuki 3, and the plane was readied for testing.
Much to the relief of all, these modifications proved to be a sound investment.
Despite weighing 100 kilos more than the first prototype, the second Ka-14 had virtually the same performance without any of the dangerous drawbacks.
Because of this, the Army Air Force also expressed interest in Mitsubishi's aircraft, and a single example was ordered under the designation Ki-18.
Though ultimately it did not impress the Army enough for purchase, as even it did not meet their borderline obsessive requirements for agility, it did spur them on to draw up a new specification for an advanced fighter.
They expected Mitsubishi would offer an extensively modified version of their own fighter, but as Mitsubishi were busy with preparing the Ka-14 for full production, only a small team could be spared from modifying the Ki-18 into the Ki-33.
As a result of this, Nakajima would win the Army competition with the Ki-27.
By late autumn of 1936, the Ka-14 had been approved for series production as the Type 96 carrier-borne fighter, also known as the A5M1.
It was relatively similar to the second Ka-14 prototype, however it featured a new engine cowling, the internal fuel tank capacity had been increased, and the rear fuselage had been slightly redesigned to further improve stability.
It was also now powered by the Kotobuki 2 Kai-A, which was rated at 580hp for take-off.
Because of these airframe changes, overall weight increased to 1500kg, which had a knock-on effect on performance, and reduced the top speed and climb rate.
As a result of this, things quickly moved on to the A5M2, which featured the improved Kotobuki 2 Kai-3A, their designations are getting rather complex now, and this gave 610hp at take-off and now drove a three-blade propeller.
Other changes included the shortening of the exhaust pipes, the splitting of the carburetor air intakes in two, and the shortening of the engine mounts to maintain the center of gravity.
The maximum speed rose back up to 426kmh, and the climb rate to 5000m was just under 8 minutes.
Though the weight had increased again, which slightly affected overall maneuverability, the increase in other performance metrics outweighed this drawback, and the A5M2 entered production at the end of spring 1937.
The outbreak of the Second Sino-Japanese War accelerated the delivery of A5Ms to operational units, with the first arriving just four days after the start of hostilities.
They first saw combat with the 13th Kokutai, the imperial Japanese equivalent of an air group, above the skies of Nanking.
Despite only being available in small numbers, the A5M enjoyed a large deal of superiority in the opening months of the conflict, as the opposing Chinese forces were mostly fielding outdated planes.
However, there were still some losses, though some of these were attributed to the Chinese fielding of Breda 27s.
Though in many ways it was the Italian lovechild of the P-26P shooter, its general profile was still similar enough to the A5M to confuse Japan's more inexperienced pilots, which led to some unfortunate incidents.
Following the capture of Shanghai, and as the Japanese army moved on Nanking, the Chinese air resistance grew much fiercer.
This was in part thanks to the influx of Soviet equipment, such as the Polikarpov I-152 and I-16.
During the offensive, which continued until the fall of Nanking, the A5M clashed with these fighters on numerous occasions.
Initially, the Soviet fighters proved to be a tough nut to crack, as the A5M only had two rifle-caliber machine guns.
However, after a month or two of relatively disappointing combat, the Japanese pilots began to take the measure of these new opponents, and their luck improved.
Though less powerful, the A5M proved to be more maneuverable overall, and the strength of its airframe proved to be more robust than expected.
In one particular demonstration of this, petty officer Kashimura was able to bring his plane back to base after losing a third of his port wing from an enemy ramming attack.
While the combat continued over the skies of China, work had begun on the A5M-2B.
This new version reverted to the Kotobuki-3 engine, which was now behaving itself, and a number of minor changes resulting from combat experiences in China were also introduced.
These included the provision for the fighter to carry two 30kg bombs, a larger windscreen, tail fin, and more importantly, came the addition of a fully enclosed canopy.
Unfortunately, all of this added more weight, which led to pilot complaints about reduced performance.
That being said, they were far more vocal about the canopy itself, which they claimed seriously limited visibility.
It was so disliked that many operational fighters would have these canopies removed by the ground crews in the field.
This eventually led to the A5M-2B having its production changed back to an open cockpit configuration.
After this, the A5M-3 was not a production model, but an experiment to test the fitting of a Hispano-Suiza liquid-cooled engine, as well as a 20mm Hispano cannon.
Though these trials produced some very promising performance figures, the design was not adopted, as the Imperial Japanese Navy wanted no reliance on foreign-built equipment.
And so, we arrive at the A5M-4, which is usually the model that this aircraft is most remembered for.
This model was specifically developed to tackle Chinese aircraft that were out of the range of the A5M-2, their bases having been moved further inland.
Externally, this new version was almost identical to the last production A5M-2Bs, upon which changes had been made to the landing gear, windscreen, and rear fuselage.
But there were some other changes.
Apart from the new engine, it also featured attachments for a 160L drop tank, which gave it an extended range of 648km.
This was later further improved, with the addition of an even larger 210L drop tank.
Built in the largest numbers, and eventually re-designated as the A5M-4 Model 24, it was powered by the Kotobuki-41 engine, which gave 710hp at take-off.
Even later, the Kotobuki-41 Kai engine was introduced, and the new variant received the designation of A5M-4 Model 34.
Both production variants were delivered to frontline units from 1938 up until 1941.
During 1939, the A5M had very few combat opportunities owing to the shrinking number of Chinese combat planes.
Most of the activity was focused around assault missions and general patrol duties around Japanese bases.
There was a brief resurgence of activity in December, when a sudden onset of Chinese bomber attacks struck the main forward Japanese airfield.
The last major air battles took place at the end of the year and the start of 1940.
The first of them involved 13 A5Ms against 20 I-16s and I-152s, of which 14 were shot down for the loss of a single A5M.
During the second engagement, 26 A5Ms fought a similar force, shooting down 13 enemy planes for the loss of just two.
Combat over China produced several aces flying the A5M, and many of these would prove invaluable for training Japanese naval aircrews in the lead-up to the conflict against the United States.
When the Pacific War eventually began, the United States and Great Britain still thought the A5M formed the bulk of the Japanese naval fighter units, and as such assigned it the codename Claude.
In fact, the only units still fielding the A5M in a non-reserve capacity were the carriers Ryuzho, Zhuiho, and Hoshio.
This resulted in many eggs on many faces when the A6M-2, the dreaded Zero, started appearing in large numbers and running circles around the older American fighters.
With the exception of the attack against Davao, no A5M-4s participated in offensive action against the Allies,
though some would see action in a defensive manner over the Marshall Islands.
The last combat sortie for the A5M took place on 7 May 1942, when the aircraft carrier Shouho was attacked by US torpedo bombers.
Two A5Ms and four A6Ms managed to get airborne, before several torpedoes and 13 bombs sent the Shouho on a one-way trip to the seabed.
Though they destroyed three US planes for no losses, all but one had to ditch in the sea due to the loss of the carrier, with the other managing to land at a nearby island.
After this, the bulk of the remaining A5Ms were kept in Japan for use by reserve and training units.
This also led to the A5M-4K, which was a two-seat training model that was introduced in 1942.
In total, 103 of these planes were built, and they remained in service until the end of the war.
Also, like many older, defunct or otherwise obsolete aircraft, these would be used alongside the remaining A5Ms for kamikaze attacks as the US Navy sailed ever closer to the home islands.
And so ended the career of the A5M, the fighter that propelled Mitsubishi into the good graces of the Imperial Japanese Navy,
and one whose combat experience led to the development of the A6M-20.
It also provided the Air Force with a large supply of experienced pilots and instructors for the upcoming conflicts with the US.
And along with the Ki-27, it led to some key changes in Japanese aerial doctrine.
All of this will be better explained in another video that I have planned, one that will take a much closer look at the air war between China and Japan.
But that is a topic for another day.
As always, thank you all very much for watching, and I'll catch you all next time. Goodbye.
