Making a Mini Desert Oasis for The Red Shrimp

Nature Fish Tank
87 followers
41 Video Views·Jul 15, 2025
Where there's water, there's life. That brings us to the oasis.
An area full of water in the middle of an arid landscape where life thrives.
What if I were to take the essence of this natural occurrence, shrink it down to a tiny size,
and put it into a glass box? I think that would be a fun concept to explore.
That's easier said than done though. A piece like this would only be possible with customization.
In this instance, I had to create an area partitioned off from the water to house the
The solution was with two pieces of glass. However, these would create a better aesthetic
when modified. I accounted for an angle that will make for a more dynamic scape later on.
As I've shown before, cutting glass is easy. It's just a matter of prepping the tool,
scoring a line, and separating the glass along the fissure.
Of course, it helps to sand the sharp edges as well.
The glass fits as before, but I had to account for another feature.
The plants require a well-drained substrate, which would quickly become
ineffective in such a confined area. The easiest solution was to drill holes
through the glass. Simple enough. I set up a guide, filled it with water,
and drilled through with a diamond-tipped hole saw.
Afterward, I cleaned the glass with isopropyl alcohol so silicone would adhere properly.
I applied a bead around the holes for knitting mesh to retain the substrate.
I did the same for the panes of glass.
And to complete this step, I let it cure for 24 hours.
I also built a secondary enclosure from glass that I cut down slightly larger than the main
tank. I assembled it like any other aquarium with silicone and anchoring tape.
After allowing the proper cure time and removing the excess, I was left with this shallow setup.
This will create a secondary reservoir, an area where water can go
after it's drained out of the holes in the bottom of the main tank.
Going slightly larger will also make it easier to remove if needed.
More on that later. For now, it's time to scape.
I've selected pagoda stone because I think the stacked layers look like something you'd
see in the desert. Before I can add them though, I need to account for this pump.
It will go in the back here, but to still have complete access to it, I'll have to create a box
around it. I cut down PVC foam, created a pass-through hole, glued them together, and placed
a barrier. I silicone'd this to the tank, and after letting it set up for a little bit, I could
finally add the rocks. Starting at the bottom, I began stacking the stones. That's what I tried
to do at least. The pieces just weren't coming together easily. I thought it might help to
integrate cholla roots, and although I got some inspiration, this wasn't working out.
I just couldn't seem to get anything to stay. I instead placed the tank on its side and tried
again. Finally, I was able to get the pieces to link up in an appealing configuration. They were
precarious though, and I didn't want them to move. So, I applied expanding foam behind the rocks and
let it cure. I pulled off the excess and continued scaping on the other side. I fit in the rocks as
before and applied more foam to hold them in and cover the back. Once cured, I used various tools
to carve it. In doing so, I wanted the foam to blend seamlessly around the stones while also
sloping up toward the top of the enclosure, creating a hill. Obviously, I won't leave it
looking like this though. I applied cyanoacrylate glue over the entirety of the foam, followed by
desert sand. As usual, this made it extremely easy to create a cohesive transition between the elements.
By this point, it was looking pretty good, but I had to get the wood back in their respective
locations. I mixed up an aquarium safe epoxy, which I used to secure the wood to the background.
If I hadn't, surely it would have floated. Unfortunately though, the anchor points were
visible, so I had to hide those with glue and sand as well. And thus concludes the hardscape. It's
fairly simple, but I really like how it turned out. I even included a spot for a waterfall,
but I won't activate that till later. I want to get the land area addressed first.
I filled the partitioned areas completely with an arid substrate mix that's suitable for the
use. Stuff you'd expect to see in an arid place, like cacti and succulents. I wanted a proper
desert look, and I can't think of anything that fits the criteria better than a cactus.
The combination of these plants looks great in my opinion.
I don't think substrate alone would have looked right. I topped it off with sand,
using a technique I shared all the way back in 2016 with the cactus terrarium.
A funnel attached to a tube makes it really easy to target where I want the sand to go,
without getting it all over the plants. The top dressing made all the difference in my opinion,
and things came together well. As for the pump, I hooked it up to a tube and elbow,
dropped it into the reservoir, and filled up the basin. I let it rip, and it looked great.
Back to the other tray I made earlier. You'll see here that I outfitted it with
a self-leveling mat so the glass doesn't get damaged. I dropped a wooden frame over it that
I created from cedar. I sent rough boards through the planer, cut them down to size,
nailed the frame together, and did a pass with a torch to show Sugiba on the wood.
Inside this, I created an XPS foam base with holes to account for drainage.
Then I dropped in the tank and self-leveling mat, which has holes in it as well.
I didn't anticipate just how well this would tie into the overall aesthetic.
Down in the basin, I dispersed a thin layer of topsoil for nutrients, followed by sand.
I sprinkled gravel on top of this for texture. That meant I could finally fill it up for real
and add the details. I sparsely placed patches of moss within the waterfall and other plants
in the water feature. I did my best to have restraint here since this isn't a jungle setup.
Up at the top, I covered the pump vault with sand discs,
which I made by coating PVC board with super glue and sand.
You know I always want that clean look, so I installed frost film on the back.
On top, I secured a light that really brought things to life.
Additional pieces of cholla wood, followed by gravel in the reservoir, more or less completed
the build. When I began, I had a rough idea of how this would look in my head,
but the result is much cooler than I imagined. I love the contrast between the desert area and
the waters beneath. I'm really glad I integrated the waterfall as well. Without movement, I don't
think this build would be nearly as dynamic. The biggest challenge was devising a method
to promote dry substrate. I wasn't sure how the reservoir would tie in, but I actually think it
makes the entire thing appear more interesting. I'm enjoying the cholla wood too. I knew it would
look neat and go with the vibe, but I selected it for another reason. All of the cavernous spaces
facilitate excellent grazing surfaces for shrimp. You didn't think I was going to leave it as is,
did you? My danio tank is bursting from the seams with cherry shrimp right now,
and I thought they would look awesome in such a design. That's why I included the
sous-faucer tong as well. It allows the shrimp to have vast colonies within it.
Even though I liked it before, it's even better with the shrimp and snails. Don't you think? Fish
like phoenix rasbora would have looked great as well, but I think the water area is a little
too small for that. Otherwise, I love how the pieces came together. However, there is one element
I wanted to include that I unfortunately had to omit. Do you remember the dinosaur plant I
showcased back in 2018? Well, I still have it to this very day. I was curious to see if it would
resurrect because I haven't hydrated it since then. Sure enough, it opened completely. That said,
I just couldn't find a spot where it looked appropriate. Maybe in another build. From the
cactus plants to the waterfall, cholla wood, shrimp, and the cohesiveness of the full picture,
I couldn't be happier with this project. I had a lot of fun exploring this concept,
and it gives me plenty of ideas for future builds. And I don't know about you,
but I'd be elated to encounter such an oasis in the middle of a desert.
