Anthropologie-Inspired DIY Trinket Dish! Easy Air-Dry Clay & Decoupage Tutorial

Craft & DIY
230 followers
13 Video ViewsยทJun 19, 2025
These dishes are lovely, I look forward to trying this craft. Thank you for sharing and the inspiration.
Comments are disabled for this video.
Hi, this is Alisha with thriftyandchic.com and today I am going to share with you a really fun
craft that is great for organizing and for home decor. I have made quite a few in the past month
only because I keep finding napkins that I am loving and want to try to see how they would
work in these cute little dishes. So these are little trinket dishes that I have been making.
They are super simple to make, they take a little time just because of the drying,
but they use napkins. Once you realize what and how many crafts you could create
with decoupage and napkins, you will start hoarding napkins, I promise. So I find my napkins
from T.G. Maxx or from Amazon. These ones I just found at T.G. Maxx, look how pretty they are,
for $2 they were on clearance. And so most of these were from either one of those sources,
this is one of my favorite ones, this was an Amazon find. And so I use these as trinket dishes
for my jewelry or for my car keys. I also, since I have been making so many, I realized they would
look really cute as candle holders and so I have been using some throughout my house for candles.
So I am going to share with you the tutorial on how to make these. So get your supplies
and let's get creating. Alright, first step is to get your clay. I like to use this DOS
air dry clay, it's super great, it's in white. And you're going to get your rolling pin and
you're going to get a bowl. Depending on what size you want your trinket dish, it will depend
on the bowl. I picked a somewhat small bowl. I covered it with clean wrap and smoothed out as
much as I can of the clean wrap. And I got a really good chunk of the clay and put it on
some wax paper. I kneaded it and then rolled it out to about a quarter inch thick with my rolling
pin. It is just big enough to cover the bowl that I was putting it on. So I placed it on the bowl,
I kind of smoothed it out with my hands as much as I can. I flattened the bottom as well as I can
so it would sit down on a table once it was dried. And then I went through with my fingers,
kind of smooth it out and then grab a knife. I just grabbed a broken knife from my kitchen,
you could do exacto knives or clay knives for this. Just go up and down, creating like kind of
like a rounded curved or scalloped edge. There's no rhyme or reason to this, kind of just end where
you do. Sometimes you have to redo it if it ended weird. And now you're going to go through it with
your finger and just smooth out the edge. You'll see that it's really rough and a lot of spots.
And so just work the clay and smooth it out as best as you can. This is also a point
where you would be able to smooth out like the peaks kind of from where the scalloped edges are.
Sometimes they might be a little bit more sharp and you want to have a more round edge. It also
helps a lot to dip your finger in some water and smooth it out with that. And so once you're done
with the edges, also work on the bowl itself. That is the part that you're going to be seeing
is the outside of the bowl. When you are done with that, you're going to let it dry for 24 to 48 hours
and then work it off. Kind of twisting and pulling and it will come off. Take some time sometimes and
now you'll see that you have still a pretty rough edge. So we're going to fix that rough edge with
some fine grit sandpaper. So just carefully go over the edge with the sandpaper and smooth it out.
Now we are going to get to the fun part. Grab your napkin and take off the top fly. You're
going to cut it in a somewhat of a circle shape, a little bit bigger than your clay bowl. At this
point, make sure that it fits in there. Trim it a little bit more. It's easier to work with when
it's a little bit smaller. Put in a small amount of Mod Podge medium into your clay bowl. Make sure
the clay bowl is dry and then you're going to place the napkin into the bowl and smooth out
any wrinkles as careful as you can because sometimes this will tear if you aren't careful
enough. And now go through with the scissors again and kind of trim it up a little bit more
and wait for this to dry. Next step is to get the paper, the sandpaper again, and take off any of
the excess that has gone over the rim. You kind of work against the rim at this point in order to
take the paper off and create that really good smooth, crisp cut right there with the napkin.
When that's all done, you're going to get some Mod Podge medium once again and put it on there.
Do a small coat. You could do a couple coats after this. Just wait for the coats to dry in between
time and get a really good kind of lacquer shine on that. And now it's time for the Rub and Buff.
I put the Rub and Buff on the edge first using a soft paintbrush. Depending on the edge, you might
want to transfer it with a sponge or I kind of use my finger too. When that's all done, flip it over
and do the whole back with the Rub and Buff. You can also choose to paint this if you like or just
leave it white. If you leave it white, I would suggest probably putting a finish even like the
Mod Podge back on it. And when you are done with the Rub and Buff, kind of go back through even
with the paint and fill in all those spots that you might have missed because you'll notice them.
Trust me, you'll probably even notice them in this video as well. When that's all done,
you have this beautiful trinket dish that's ready to go. So I like to use mine on my nightstand to
put my rings on at night. I also use them for my keys on my entryway table. It adds that little pop
as well. And I've been using them for my candles. They are this cutest little tray for your candles.
So be sure to check back for more do-it-yourself
and decor videos or go to my website, checkthirtyinchic.com.
