Gold Jewelry Techniques: Granulation

Ancient Art & Jewelry
19 followers
14 Video Views·May 15, 2025
Watch a video demonstrating a granulation technique used in gold jewelry making.
Featuring Jenna Wainwright Fennell, Conservation Preparator
Produced in association with the exhibition Silla: Korea's Golden Kingdom, on view at The Met Fifth Avenue from November 4, 2013, through February 23, 2014.
https://www.metmuseum.org/exhibitions...
Production Credits:
Director and Producer: Kate Farrell
Editor: Kate Farrell
Cameras: Kelly Richardson, Jessica Glass
Lighting: Ned Hallick
Original Music: Austin Fisher
Audio Post-Production: David Raymond
© 2018 The Metropolitan Museum of Art
A gold dome is created as a base for applying the granulation.
First, a small gold ring will be fused to the surface around which the granules will be placed.
The ring is dipped into a solution of glue, flux, and copper salt, diluted with water.
Then, heated with the torch, the moisture in the glue solution is very gently burned off.
The air of the torch can disturb the placement of the elements to be fused.
When dried, the glue turns to a dark brown and the piece is heated more aggressively,
just to the point where the surface melts and the ring is fused to the surface.
Now, the granulation process begins.
Tiny granules are made by snipping fine gold wire over a charcoal block.
Separating the pieces on the block will prevent granules from melting into each other when heated.
The tiny pieces of gold ball up into granules when heated to melting point with the torch.
The process is performed on a charcoal block because the charcoal creates a reducing atmosphere,
one that consumes the oxygen, therefore preventing oxidation or discoloration of the piece.
The tiny granules are dipped into the glue solution and placed individually onto the workpiece.
The tension of the solution temporarily holds the granules in place until the glue dries.
Again, the glue is gently dried with a little heat without directly applying the flame which
would scatter the granules. Once the glue turns brown, more heat is applied until the granules
fuse to the surface and to each other. If the heat is applied for an instant too long, the whole
piece could melt. A few granules may not fuse on the first try and the process may be repeated,
which is the advantage of fusing the granules rather than soldering.
