Talento Automatic Coffee Machine Solenoid Valve Maintenance

KoffeeOne
96 followers
Apr 18, 2025
Talento Automatic Coffee Machine Solenoid Valve Maintenance
www.koffeeone.com.au
solenoid valves flow meter and check
valve access for access to the solenoid
valve assembly the engineer needs to
make sure that the machine is Switched
Off and then remove the left side panel
using a Philips screwdriver loosen the
two screws on the top
panel the tools required are 7 12 and 14
mm
wrenches A Philip screwdriver and
Clippers flow meter and check valve the
flow meter is located at the base of the
solenoid valve
support to replace disconnect the wiring
connections and the inlet and Outlet
pipes in
Teflon using a 12 mm wrench and with a 7
mm wrench the two screws fastening the
flow meter to the
base the check valve body is located at
the flow meter
Inlet solenoid valves the top part of
the left side
panel from the left is where we find the
solenoids for steam hot water cappuccino
maker and air for the coffee
circuit lower down from the left are the
add water coffee pouring and automatic
level
solenoids coffee solenoid valve to
remove the coffee solenoid valve the
engineer needs to switch off the machine
and open the front
panel first removing the ground drawer
and turning the key
anticlockwise from the front position
with the door open the engineer needs to
remove the pouring tube pressing on the
ring and pulling the Teflon tube
outwards insert a 4 mm Teflon
pipe remove the nut with a 14 mm wrench
and then push the fitting
inwards to remove the coffee solenoid
valve definitively the engineer will
move to the left side of the machine
using a Philips screwdriver remove the
solenoid valve
head
then a 12 mm wrench to remove the inet
pipe and a 7 mm wrench to remove the nut
securing the solenoid valve to the
frame slide out the solenoid valve and
remove the outlet and waist
pipe at this stage the importance of the
4mm Teflon pipe will become evident
since it makes it easier to recover the
fitting and therefore to refit the
parts solenoid valve replacement for all
solenoid valves excluding the coffee
solenoid the removal procedure includes
the
following remove the head of the
solenoid using a Philips head
screwdriver take out the inlet
pipe use a 7 mm wrench to loosen the nut
locking the valve to the
frame slide out the solenoid and then
remove the outlet pipe and waste pipe if
present
