Talento Automatic Coffee Machine Grinder Components

KoffeeOne
96 followers
Apr 17, 2025
Talento Automatic Coffee Machine Grinder Components
www.koffeeone.com.au
Grinders containers and micro the
engineer needs to switch off the machine
remove the ground's drawer
turn the key anti-clockwise and then
open the front panel
the tools required are Phillips and
Flathead screwdrivers 13 millimeter
wrench and three millimeter Allen key
to remove the coffee containers the
service engineer needs to close the two
tabs that close the container
alongside the tab is the screw to adjust
grounding fineness
after this the engineer can remove the
coffee container with the magnet in the
bottom
the magnetic micro switch is located in
the top part of the machine
grind access and changing
after removing the containers remove the
four Phillips head screws in the top
panel
and disconnect the wiring
the two micro switches for the
containers and the micro for the
decaffeinated coffee Chute are located
in the back part of the top panel
the cover of the decaffeinated coffee
Chute has a magnet to enable a
decaffeinated function
to access the Grinders the engineer
needs to clean out suction the coffee
beans remaining in the grinder
and then remove the left and right side
panels by taking out the screws on both
to change the Grinders the engineer will
need to loosen the adjustment worm screw
that adjusts grinding fineness accessing
the side parts of the respective
Grinders with a three millimeter Allen
key and then to slide the regulator from
the top
the service engineer will then loosen
the top ring nut on the grinder
and clean the seating to remove any
coffee deposits
the next stage is to disassemble the
Grinders using a flathead screwdriver
when refitting the parts the engineer
will need to screw on the top grinder
completely until it touches
and then turn it half a turn back
then refit the adjustment screw secure
it to the grinder and reassemble the
whole unit
use the relevant screw to adjust
grinding fineness to obtain the desired
coffee quality
ventilation system
the service engineer will need to switch
off the machine
remove the grounds drawer turn the key
anti-clockwise and then open the front
panel
to remove the coffee containers
block the two tabs closing the container
and then it will be possible to remove
them
and the four Phillips head screws on the
top panel
before disconnecting the wiring
as well as the Grinders in the top part
of the machine it's possible to see the
conveyors of the two types of ground
coffee
the fan for the ground coffee shoot
0.08 amp and the fan to cool the
containers 0.15 amp
which serves to keep Coffee Bean quality
at a constant level
changing the condenser
to access the condensers the service
engineer will have to switch off the
machine and remove the rear panel by
taking out the two screws with a
Phillips head screwdriver the engineer
has to remove the right side panel too
to remove the condensers take off the
protective cap and disconnect the Fast
Times
using a 30 millimeter wrench the
engineer can remove the nut on the side
panel of the condenser and then remove
the condenser itself
