Talento Automatic Coffee Machine Daily Cleaning Procedure

KoffeeOne
96 followers
Apr 17, 2025
Talento Automatic Coffee Machine Daily Cleaning Procedure
www.koffeeone.com.au
http://www.koffeeone.com.au/Talento_Automatic_Coffee_Machine_Cleaning
daily cleaning and maintenance
introduction
before carrying out any exterior
cleaning set the machine to zero power
i.e machine switched off
chamber cleaning brush with the machine
off slide out the ground drawer and open
the door
using a brush clean any coffee build up
or residues from the piston and chamber
of the pouring group and clean any other
parts that are soiled with coffee
ground coffee tunnel cleaning brush
with the machine off slide out the
ground drawer and open the door
open the decaffeinated coffee drawer and
use the brush provided to remove any
coffee residues on the conveyor sides
tray
clean the drip tray with hot water and
soap
using a brush if necessary
full wash
to wash the machine switch it on and
proceed as follows
place a container of water alongside
and insert the suction tube
then add the novosimonelli specific
cleaner pulley milk
then press and hold down the two times
clean key for about six seconds until
the display reads washing
open door and insert detergent
close door
open the front door and insert the nova
simonelli detergent tab pulley calf
inside the pouring chamber
clean the bottom of the top piston
the shower with a damp cloth and close
the door
the washing process will start
automatically and the display will show
the chosen function
the dose keys are disabled during
washing
at the end of the cycle the display will
read rinsing press enter
place a container of clean water
alongside the machine and press enter
the machine will carry out a rinse cycle
and the display will read rinsing
pouring nozzle wash
to access the pouring nozzle the service
engineer will need to switch off the
machine and unhook the plastic cover
from the pouring nozzle
and then remove the pouring nozzle by
pressing the clip at the back and
unhooking it from its original position
remove the top of the steam and milk
pipes
and take the cappuccino maker out of the
pouring nozzle by sliding it upwards
then dividing it into its four parts
and washing them all carefully in cold
water
to refit the parts follow the
instructions in the back of the control
panel
you
