Talento Automatic Coffee Machine Water and Milk Pump Components

KoffeeOne
96 followers
1 Video View·Apr 17, 2025
Talento Automatic Coffee Machine Water and Milk Pump Components
www.koffeeone.com.au
pump and water stop
solenoid access the engineer needs to
switch off the machine remove the
grounds
drawer and turn the key
anticlockwise and then to open the front
panel the equipment required is 7 and 12
mm wrenches long and short Phillips head
screwdrivers flathead screwdriver
Clippers and clamps
pump and pressure gauge adjustment to
adjust pump pressure open the front
panel first sliding out the ground
drawer and turning the key on the top
panel
anticlockwise use the adjustment screw
turn it clockwise to increase pouring
pressure and anticlockwise to reduce it
pressure needs to be set while pouring
coffee with the machine in standby mode
the pressure gauge will read zero due to
the water stop
solenoid while pouring the pressure
needs to be registered at 9
bar pump replacement remove the ground
drawer open the door and remove the
water
tray then remove the four screws
supporting the bottom front
panel remove the lower screw of the
Brewing
unit and then take off the panel from
the
front the engineer will need to open the
water in Inlet fitting by loosening the
screw with a 12 mm
wrench then remove the two outlets using
the same wrench on both
unions use a Philips head screwdriver to
remove the clamp connecting the pump to
the
motor then take out the
pump
motor
replacement after separating the pump
from the
motor use a 7 mm wrench to remove the
four screws under the
machine the service engineer then needs
to free the motor from the assembled
machine and disconnect all connected
wiring follow the video to see whether
the motor has been removed with or
without the
pump water stop
replacement remove the grounds drawer
and the water
tray open the door and remove the ground
drawer and the water
tray then remove the four screws
supporting the bottom front panel and
take off the panel from the
front take out the water stop solenoid
Outlet tube and the two connection fast
on shut off the incoming water and
disconnect the talento water inlet
pipe use a short philli screwdriver to
remove the two screws under the coffee
machine
cut the clamp securing the drain pipe to
the front of the machine with the
Clippers and then replace the water stop
valve
