Talento Automatic Coffee Machine Front Door Components

KoffeeOne
96 followers
Apr 17, 2025
Talento Automatic Coffee Machine Front Door Components
www.koffeeone.com.au
door introduction
on the outside of the door starting from
the bottom we can see from the left the
hot water wand
the pouring nozzle
and the steam wand we can also see the
housing for an optional Auto steam
nozzle probe
in the top part we have the button pad
and the display on the right side of the
button pad there is a USB port
inside the door at the top is the flat
wire connecting the display
while in the center to the left is the
steam Inlet tube on the right the hot
water tube
and in the center the guide to move the
nozzle with the guides for the tube
the service engineer will need the
following tools Phillips head
screwdriver 2.5 millimeter Allen key and
a seven millimeter wrench
display and button pad it's possible to
access the display and button pad by
moving the frame up removing the
membrane and disconnecting the flat
wires
using a Phillips head screwdriver it's
possible to remove the display board
taking out the four screws
and then the flat wire connecting to the
main circuit board
ing nozzle tunnel and guides the pouring
nozzle is located in the front of the
machine
the service engineer will need to switch
off the machine and unhook the plastic
lid from the pouring nozzle
the pouring nozzle contains the
cappuccino maker with the inlet pipe for
the steam in Teflon at the top
and the milk pipe in white silicone on
the right
the blue pipe is for coffee
while the red pipe is to add hot water
to replace a pipe inside the pouring
nozzle the engineer will need to open
the front door and unhook the plastic
lid from the pouring nozzle
to remove the milk pipe for example
unhook it from the cappuccino maker
and push it inwards pulling the other
end
to refit the pipe put it back into the
guide and thread it out through the
corresponding hole in the front panel
ground drawer and micro open the door
and remove the ground drawer there is a
magnet inside the drawer that closes a
micro inside the machine
the micro signals the presence of the
ground drawer
Steam and hot water wands
to remove the steam wand it's necessary
to slide out the red steam pipe
remove the three hex head screws with a
2.5 millimeter wrench
and then slide off the wand and the
fitting from the front panel
in the picture we can see all of the
parts of the wound especially the Teflon
seal
which makes Wonder movement more rigid
in line with the tightness of the lock
screws
it's therefore possible to adjust one
rigidity
to remove the hot water wand it's
necessary to slide out the red pipe
located inside the door
remove the three 2.5 millimeter hex head
screws being sure to support the glass
before removing the last screw
the wand can be removed from the front
of the machine
in the picture it's possible to see all
of the parts of the wand especially the
Teflon seal which makes wand movement
more rigid in line with the tightness of
the lock screws
glass replacement
to remove the right hand glass it's
necessary to remove the steam wand
use a Phillips head screwdriver to
remove the bottom part of the front door
the glass is attached to the door via
bayonet fitting
and can be removed by sliding it
downwards remember to support the glass
by the hole for the steam wand to
prevent it from accidentally falling
to remove the left glass it's necessary
to remove the hot water wand
and before removing the last screw
securing the wand be sure to support the
glass
hinges to remove the fixed hinges take
out the two support screws with a
screwdriver
the height of mobile hinges can be
adjusted using the two screws the
central screw serves to make lengthways
adjustments
to remove the door with adjustable
hinges take out the screw inside the
hinge and then release it pulling out
the door
