Talento Automatic coffee machine Programme Settings

KoffeeOne
96 followers
Apr 17, 2025
Talento Automatic coffee machine Programme Settings
http://www.koffeeone.com.au/
self-service option with self-service
enabled the functions left grinder and
two times of the touchpad and manual
stop of the beverages are disabled
password change it's possible to set a
new password to access the programmable
functions in service engineer mode
press enter to open the sub menu
enter the old password the standard
password is four times the left grinder
key
enter the new password as a combination
of Four Keys
confirm this same password
there are no other menus press reset to
quit the dose programming mode
to quit the programming mode press the
up Arrow key as far as save data
and press enter to confirm
save data
press the enter key to save all the data
entered during programming
press reset to quit the programming mode
without saving the data
machine switch off to switch off the
machine press and hold down the off key
for 3 seconds
group adjustment
to change the position of the micro
switches proceed as follows
switch off the machine and press the up
and down arrow keys
the display will read test
press the two times clean key to pass
through the heating element and motor
test
the service engineer will need to remove
the grounds drawer open the door and
press the keys six top
or seven bottom
eight intermediate to check the correct
position of the group
press key number six to check the top
position of the group I.E when the
magnet closes the top micro switch
the correct micro closing position must
be when the whole top piston seal is
inside the chamber
press 7 to check the bottom position of
the group I.E when the magnet closes the
bottom micro switch the correct bottom
position is when the shaft enters the
worm screw and the palette makes a 90
degrees movement compared to the work
surface
press 8 to check the intermediate
position of the group I.E when the
magnet closes the intermediate micro the
correct intermediate position is when
the distance between the coffee Chute
and the palette is five millimeters
to change the position of the micro
loosen the screw by half a turn and set
the micro up or down before tightening
the screw again
use the relevant keys to check the new
position
right grind adjustment
to adjust grinding fineness on the right
grinder use a flat head screwdriver
turn clockwise to increase fineness
and anti-clockwise to reduce it
when adjusting for finer grinding we
recommend tightening by a maximum of one
turn and then testing the effect by
pouring at least two cups of coffee the
first of which should be poured using
the previous grinding setting
left grinder adjustment
to adjust grinding fineness on the left
grinder use a flat head screwdriver
turn clockwise to increase fineness and
anti-clockwise to reduce it
when adjusting for finer grinding we
recommend tightening by a maximum of one
turn
and then testing the effect by pouring
at least two cups of coffee the first of
which should be poured using the
previous grinding setting
milk temperature adjustment
use the choke to adjust temperature
turn clockwise to reduce flow and
therefore increase temperature
turn anti-clockwise to increase flow and
therefore reduce temperature
milk adjustment
use a flathead screwdriver on the top
left side of the machine to adjust the
air and therefore the foam in the milk
turn anti-clockwise to increase foam and
clockwise to reduce it
we recommend performing this operation
while actually pouring milk
turbo steam adjustment
the turbo steam steam wand is comprised
of an outer pipe in stainless steel with
air Inlet hole and an internal pipe in
Teflon
to adjust the size of the bubbles
tighten the Teflon pipe to increase air
and therefore the amount of foam and
loosen it to reduce air and therefore
the amount of foam
default adjustment is to have the Teflon
pipe covering half of the hole in the
bottom of the steel pipe if the hole is
covered the foam will be compact if it
is completely open the foam will contain
larger bubbles
