How to Make Box Joints With a Tablesaw Jig

Sparky Deal
161 followers
I used a 3/4 dado stack to cut out my box joints
#DIY #howto #woodstuff
In this video I want to show you how I use this sled that I made for my table saw, along
with a dado stack, to make these drawer boxes.
So the first thing that you do is you butt your piece up to your key that you have right
there, that's what that groove is where your workpiece will slide into, here you'll see
in just a second, and boom, it slides right in there, and that way you get perfect spacing
every single time, and then you make your cut, slide it over, and so on and so forth.
One thing that I did incorrectly the first time that I made this, I wasn't paying attention
to my front and back and side pieces, and the order in which I was cutting these box
joints.
So one thing you want to see here, is you flip it, so that way it's completely mirrored
for your two front and back pieces, and then in a second here, I'll show you how you get
the continuous joint, so that they interlock perfectly once you start doing your side pieces.
Alright and then what you want to do is the very first cut that you made, you want to
put that side into your key, so that way your next piece, which these are going to be my
side pieces, will butt up to that, and that's how you will make your first cut on your side
pieces.
Sorry I'm just going really slow to make sure that I get a nice clean cut.
Alright and then once I have that, I'm going to make that same cut again, so that way I
don't have to put this piece back and use it again, and now I can just move right along
and make all of my cuts, and again they will mirror each other perfectly, and then when
you go to put it together, mine were pretty snug, so I used a little sacrificial piece
here to hammer them in, so I wasn't just using a mallet right on those finger joints.
And then you see here, it goes together snug, check for a square before you glue it up,
but that's it.
