Calibrate Your Probe System Faster - Probe Calibration Kits - Haas Automation, Inc.
Comments are disabled for this video.
Probing is basically magic. Beep beep and our offsets are set. Another beep beep beep and our
parts are measured. Now none of this magic is possible if our probes, both spindle and tool,
are not properly calibrated. And the easiest way to calibrate is with one of these probe calibration
kits. Now these are basically test bars built for probing. It is marked with a known length.
This is a known gauge length, an exact distance from the tip of the tool to a theoretical gauge
line that cuts through the tool's taper. Now for a CT40 or SK40 holder, this gauge line
rests at a spot where the taper is exactly 1.75 inch, 44.45 millimeters in diameter.
Now this gauge line serves as a starting point or datum for all of our other probe measurements.
Now this gauge line is really hard to measure on a tool, but we don't have to because we have
picked up a test bar that has the gauge length written right on it. And we can use this tool
to calibrate our entire probing system. We will use this test bar to set up our tool probe
position. We can then use our calibrated tool probe to set our spindle probe length. And finally,
and this is pretty cool, we can use a magnetic ring gauge from our kit to calibrate our spindle
probe diameter. This is so good. Now we could use any ring gauge for this, but we would have
to carefully hold it, lightly clamping it to our table in some way. Now if a vise had been in the
way, we would have had to pull it out. By the way, never ever hold a ring gauge in a vise,
no matter how lightly you clamp it. It could deform the gauge. But we don't have to worry
about any of this because we have a magnetic ring gauge. All we have to do is set it on a clean,
flat surface. Even if a vise were in the way, we could just set it on top of the ground surface
on top. Now this becomes even more of a concern when trying to calibrate our probe on a horizontal
mill, where our fixtures can make the process really difficult. Difficult for those without
a magnetic ring gauge. For us, it's a piece of cake. You can tell that I'm a big fan of test bars
and magnetic ring gauges. I have used them for decades. Now this set came out of my toolbox and
they're great, except for the fact that they cost more than a thousand dollars as a set.
Now Haas is about performance and value. Bang for the buck. I've been using this probe calibration
kit for about three years now and they are excellent. They have done everything I need
them to do at one-third the price of some competitors. That is value. One of the reasons
we can do this is because we focus on low runout and roundness. We don't require an exact 5 inch,
127 millimeter length, or an exact 0.5 inch, 12.7 millimeter diameter. We have the tool
precision ground to within a range and then measure the exact gauge length and diameter of
the tool and etch that value onto each gauge. Like this ring gauge here, it measures 1.59180
inches, but that flexibility saves us and you money while giving us an end result that is just
perfect for calibrating our probes. That is value. Such a great product. Enjoy the little things.

