FREEWING F-22 90MM AS3X+ TEST MAYBE? X2 by FGFRC
Feb 8, 2025
Comments are disabled for this video.
Well hey folks, Fat Guy Flies RC. All right, y'all saw me fly my 70 M-80, so now it's time to bring
the 90 F-22 Raptor out and have some fun with her. I have gone in there, updated the receiver
to the AS-3X Plus. We'll go over those settings when we get done, and I've also reinforced the
front nose mount with a wood plate in the inside here. I'll show that to you afterwards,
but right now let's go up and have some fun. 6000 HRB, and we got a four minute timer.
Check my CG. I think we're okay. All right, KM model afterburner inside there.
I haven't flown this plane in a while, and this was before they released it with reverse thrust,
so I don't, I have the upgraded motor, but I do not have reverse thrust. So if I would have waited
a few months, I could have got the one with reverse thrust, but I, you know, they don't
give you a heads up about, hey this is coming out. They want to sell what they got in stock,
and I can't blame them. All right, reset my timer. All right, right, left, up, down,
left. Okay, timer set for four minutes, flying them high rates. Here we go. Definitely need
That was fun. Time remaining two minutes. Gear down. Landing flaps.
Whoa, definitely not on a good surface to land there, but that's okay.
Flaps off. I'm gonna go to mid rates now. I'm gonna switch it to mid rates, see if I
like that a little bit better. She's awfully touchy on high rates. All right,
and push it for one more. Yeah, I think I like my mid rates better. Gear down. 20 landing flaps.
I'm being aggressive, but that's okay. I don't have reverse thrust. That'd been the perfect
opportunity to use it. A lot of fun to fly, boy. I'd forgotten how much fun she is to fly.
All right, we were nine seconds over. Let's go back to the bench and talk about her.
All right, first off, look at that beautiful KM model afterburner.
All right, let's talk about what I did to the secure. I noticed that my nose,
this, had a lot more play in it than that does. That's actually pretty solid. What I did was,
instead of getting a whole new mount and everything, I just took the gear out and I
put in two solid pieces of packing wood, okay, laminated them, well, epoxied them in and then
ran two hard screws through it, holding this plate and everything and holding that plastic
mount and all that in place. That way, that gear, the whole assembly is rock solid. It's
secured by all of that, okay? While we're here, we'll go ahead and check our battery.
We had nine seconds over on a four-minute timer with a HRB6000, 35% left. So really,
four minutes hitting it hard, you know, maybe four minutes and 20 seconds if you're a little
more conservative, okay, to show you my placement real quick. If you look in the plane, you've got
this wood tray and you got your first little cutouts where you could put a strap. Well,
if you put your battery very even with those cutouts, a 6000 there back, 5000 back, 6000 back,
that's where it shows CEG pretty good. All right, let me, I don't remember the actual numbers, but
the numbers will be in the description of the video. I did. I didn't? I thought I checked it.
Because I swore I checked it. 35% left. If you check it, you didn't say it. Oh, okay. Well,
I had 30, 30, 30 some odd percent left, 30, 30, 35% left. So that's fine. The markings on top,
if you find his hard, hard point here, about an inch past that hard point, that triangle
is where the CEG point is. Okay. And I'll check her like this, put my, okay, get her level.
And she pretty good right there. The underside, if you follow this weird panel, this jagged panel
line, go straight in or find this hard point and go in about half an inch or an inch.
That's where she CEG is there. And she's pretty good. All right. Let's talk about rates and we'll
go over the AS3X plus settings. Now the plane rates, just the rates of the plane.
I ended up switching to my mid rates. I seem to like that better, but let me show you my high
rates right off the bat. High rates, aileron, a hundred percent, 50% expo high rates, elevator,
a hundred percent, 50% expo, rudder, a hundred percent, 50% expo. But I found that to be just
a little too twitchy. Mid rates, aileron is 90, 30% expo, mid rates, elevator, 70, 30% expo,
rudder, 90 with 30% expo. That seemed to be a little more to my liking. Okay.
There is a small amount of elevator to flap mix with flaps up is a negative hundred on spectrum,
take off negative 20 with a 2% up elevator. And then landing is a positive 85
with a 7% up elevator. No, no takeoff is a 2% down elevator
and landing is a 7% down elevator. Okay. Yeah. It's down because it just, it's just a slight bit.
Okay. All right. So take off negative 20, 2% down landing 85 with 7% down. All right.
AS3X settings. Okay. Now these seem to really get this plane locked in the way I like it.
I reduced the gains. Sorry. I reduced the gains from 40 to 30 on the roll
from 50 to 40 on the pitch and from 60 to 50 on the yaw priority, a hundred down from 140
on all, all axes, heading zero, um, stop lock, reduce it all, all raise everything to 50,
release 55, 55, 75. And that's the only thing I've changed. Everything else was whatever,
whatever the stock is default is. I don't have a nose wheel gyro settings. I've only got a six
channel receiver and I need retracts and flaps. So Hey folks, Fat Guy flies RC. Well, I want,
did a flight while ago, made a big deal about how good the AS3X and everything was installed
and working. And it just, it just tells you how stable this plane is naturally because I flew the
whole thing in manual mode. I didn't even have AS3X turned on, duh, but she still flew great.
So now we're going to fly with AS3X plus engaged, but I'm going to go back to high race just to see
that way I have a more positive comparison. All right. 90 free wing. Their first edition
of their success. This doesn't have reverse thrust. I got it before they sold that
before it came with got a KM model afterburner in there. Okay. Take this beautiful plane up,
have some fun with her. All right. The only lights are the KM model afterburner
and the front landing light. All right. I'm going to take off flaps right off the bat. Here we go.
Well, I can tell you there's a big difference. Oh yeah, man. And she flew so well in manual mode,
man. She's even better. It's just the feel how she feels. Oh boy. Talk about a difference between
Remember, I don't have thrust reverse. Okay. Flaps up. A little Tokyo slide around there.
My gear mod seems to be doing really well in that front nose gear.
I went in there and reinforced the whole assembly with a hardwood plate
and then poxied it all in. All right. I'm going to do takeoff flaps a little more.
Now I don't know which ones I like better. They all three of them fly so good.
Landing flaps. Remember, I don't have reverse thrust.
Kept her on the runway. Okay, honey, if you'll just stay right there,
we'll do an after battery report real quick. Flaps up. Okay. I'm going to give you my AS3X
settings real quick. My regular airplane settings that I flew in now. I went them back to my high
rates. 90%, 30% expo on the, or 50% expo on the ailerons. Let me show you what that looks like.
100% or 90%, 50% expo. Elevator, 100%, 50% expo. Rudder, 100%, 50% expo. Okay. Flaps settings.
Flaps up are negative 100. Takeoff are negative 20 with a 2%
down elevator. And then landing are positive 85% with a 7% down elevator mix. All right.
AS3X settings are from the forward programming. Prop secured. I didn't have AS3X on last time.
I would, I would have known immediately. My gains are down from the stock from on roll from 40 to
30 on the pitch from 50 to 40 and on the yaw from 60 to 50. My priorities are all at 100 across the
board. My headings are zero. I don't do anything with the headings. Stop lock down up from the
default 35 to 50 on all settings on all roll, pitch, and yaw. Stop lock. I left that in stock
at 55, 55, and 75 on pitch, roll, or roll, pitch, and yaw. And I didn't change any other AS3X
settings. Okay. Do not have the nose wheel gyro installed because I don't have an open channel
for it. And I had 30 seconds left on a four minute timer. And let's see what kind of juice
is left in the tank. Trying to hurry as I still got two more. Unplug that beautiful KM model
afterburner. Okay. I still had 42% left. I mean, I could have gone around and flown for
really a full four minutes easily. Maybe a hair bit, a hair bit over maybe, but not much.
All right, folks. Well, there you go. That is the 90 millimeter F22 when they was first
releasing the 6S before they came out, reverse thrust and everything. She's holding up really
good. I don't know. The backing plate that the whole wood, the whole plastic assembly
goes into the fuse to hold the nose gear in. I took it out, put in a solid hardwood packing piece
of packing wood, and then epoxied that in and screwed that whole assembly into that packing
wood there. And that's why I say, when you open up these models and they got bits of wood and
pieces in the foam, save that stuff. You'll repurpose it later. But that's just a good
looking plane. The only thing I've done other than that mod, oh, I did glue the nose cone on
because I kept breaking it. So I just glued it on. Gave her a clear coat and KM model afterburner,
and that's a great flying jet. And with the AS3X plus engaged, especially them priorities
at 100 all the way around and 50 for the stop or for the release. Yeah, or the stop. I really
like the way she flies. God bless y'all. Don't forget, Fay family and friends, and then Raptors.

