How to Make Potato Pavé

Health Food
429 followers
Potato pavé.
They're a pain in the ass to make,
but super crispy on the outside,
super creamy on the inside.
I mean, it's so good, I had to take a second bite.
Potato pavé, potato mille-feuille,
thousand-layer potato thing,
whatever you want to call it,
it's just potatoes, butter, and salt baked through,
pressed, chilled, cut, deep-fried,
and what you get is crispy on the outside,
fluffy and creamy on the inside.
It's like the ultimate tater tot.
We're using russet potatoes.
Russets are great because they're high in starch,
low moisture content, and that starch is really helpful
because we're looking for starch gelatinization,
and that's gonna lead to a crispier result.
I wouldn't really use a Yukon Gold,
which is more waxy and high moisture content,
so it won't be as crispy.
You want to use a specific size of potato.
This one is pretty even.
It's also pretty much the width of the loaf pan,
and it'll give me some good slices
without too much waste.
We'll get to peeling.
Just nice, even strokes, and that's your guy.
For now, we're gonna keep them in water.
Before we even get slicing,
we need to make sure these are trimmed,
so I'm just gonna trim it so that it sort of fits this way,
but I just want to make sure
that I have pretty even slices going across,
so it makes my job a lot easier.
We have all of our potatoes trimmed up.
They're about four and a quarter inch,
so that's exactly the width this way of the loaf pan.
In terms of the potato amount,
this is a little over two kilograms of potatoes,
and that's standardized to this loaf pan.
This is an eight and a half by four and a half
by two and a half-ish loaf pan,
and we found that after peeling and slicing and everything,
you get around 1,500 grams of potato,
and that'll take you up to almost the top here.
We're gonna get a slicer or mandolin.
I have a big container of water,
and this is gonna be important to soak our potatoes,
but more importantly, this prevents oxidation,
so there's an enzyme in potatoes called polyphenol oxidase.
Basically, when you peel or cut open a potato,
you're exposing it to oxygen.
That enzyme, when exposed to air,
gets to work on the polyphenols that are in this potato,
and it turns it brown,
and that definitely will affect
the look of the finished pavé.
You're going to have some waste when you do this,
but that's sort of the reasoning behind the trimming first,
and that streamlines the process,
so you're getting these even slices.
It's not the end of the world.
If you have a lot of trim, you can use it for mashed potatoes,
you can use it for stir-fries or whatever.
So we're gonna be shooting for
between 0.8 and one millimeter, about this size.
All right, so this is our last potato,
and you'll notice you are going to have
some waste doing this,
but the payoff, I think, is worth it.
At this point, we just need to dry them,
because we want to remove as much water as possible.
My setup is half-sheet pan.
It's got two layers of towels.
Got another one to blot dry.
Got a landing spot here, and then we have our potatoes.
Pretty simple, just gonna line these up.
Just grab a fistful, really, and just go for it.
This step is very time-consuming,
and if you've got the patience
and if you're willing to put in the effort,
it's gonna be great.
I've got my lineup of shingled potatoes.
Just gonna blot it dry.
Don't have to go crazy.
Just gonna pick them up, and that's all she wrote.
What would happen if the potatoes were wet
and I built the pave?
Some moisture is good.
You want that water for starch gelatinization,
but too much can be gentrimental to the cooking time
and possibly to the finished texture.
Coming up on our last tray here.
Towards the end, you see the longer they sit in the water,
almost the more curled they get.
Those are lined up.
Get your towel, and that's it.
Bit of a long, boring job, but it's done.
So our potatoes are sliced.
They're rinsed.
They're dried.
We're ready to build, but before we do that,
we gotta coat them in a little bit
of clarified butter and salt.
First, let's make a parchment sling.
There are a lot of different ways to do this,
but a really simple way is to take a half sheet here,
and I'm really just interested in the length here,
and so I'm gonna fashion a sling that nestles this way.
So to do that, I just eyeball this,
and I wanna make it line up with the length
of the pan, more or less.
Just make a little fold there.
We get a nice crease.
There's our sling.
We spray the bottom of our pan and the sides.
We take our sling, and we just plop it right in,
and now we are ready to build.
We've got our potatoes.
We gotta coat them with about 12 tablespoons
of clarified butter, five grams of kosher salt.
The reason why we're using clarified butter here
versus just melted butter is that butter has whey in it
and milk proteins that will brown prematurely,
and so clarifying removes that whey,
and it prevents this from really browning excessively.
So everything's coated in butter.
We're ready to build.
We have our slices.
They've been cut pretty much to the width of the pan.
This is a really tedious, time-consuming,
high-effort step, but it's really the most important step
in this whole recipe.
You take the time.
You'll get rewarded with an amazing pavé later.
We took the time to trim these potatoes lengthwise,
pretty much to the width of the pan,
and we're just gonna shingle them now,
and it's more or less four potato slices per layer
with a slight overlap, and then I've saved
these last four really nice slices for the top
just as a little added insurance.
At this point, I'm gonna grab a second loaf pan,
gonna fold over this parchment,
get a little package like that.
With our second loaf pan, I'm just gonna press down
with even pressure.
You'll see some creep up the sides here.
That's okay.
We'll address that later.
As for baking, we need to cover this really well.
We wanna trap all that moisture in there
so that we can gelatinize the starches.
If we were to leave it uncovered,
it would brown prematurely on the top,
and that's not necessarily what we're looking for.
So we've got some foil.
Go over the top, and then crimp.
And as for the rest of this baking setup,
this is gonna go into an oven set at 300 degrees Fahrenheit
for around two hours until a skewer comes out really clean
and then there's no resistance.
All right, so this has been baking for around two hours,
and we're just gonna open it up and test into it,
see if it's done.
This is a needle probe, but you could use a cake tester,
a wooden skewer, whatever you got, and super soft,
like literally no resistance, super clean.
It's done.
Now we have to press our pavé.
Pressing is a really important step for this recipe.
If we were to leave it unpressed,
you'd probably discern all the layers a lot more
and break apart on you.
We do want some cohesion here.
We want some firmness to it.
It ensures that the layers actually stick to each other
so you get a more cohesive slice.
So how do we weigh this down?
You got a ton of options.
I found the easiest thing to do was to use another loaf pan.
If we were going to press it, right,
it wouldn't get all of the edges.
So I cut out a piece of cardboard
and then wrapped it in foil, taped the ends,
and it's just trimmed.
So I'm gonna fit it right in just like this
and put on our second loaf pan.
Be sure that you're pretty centered when you're doing this
and just press.
I'm applying some decent pressure here.
So that's well-pressed.
I want to weigh it down even more
so that over time, as it sets in the refrigerator,
it keeps that shape.
You could use, like, soup cans,
anything that really fits in here,
but we found that a brick fits really well.
So this is gonna chill at least eight hours,
and that's really important to set the starches
and to set their overall shape.
We'll pop this in the fridge, leave it overnight,
come back to it.
We'll unmold it, cut it, and fry it.
Our pavé has chilled overnight.
It's set really well.
It's been weighted down.
We're ready to unmold.
First things first, take our big old brick out.
So you'll notice everything is stuck together.
That's all that clarified butter
that has solidified as it's chilled.
We need to apply some heat to unstick it,
and the best way for me is a blowtorch.
Obviously, you could just flash it in the oven
if you're not comfortable with a blowtorch,
but this is fast, and I like torching things, so.
Let's see if this slides out.
Perfect.
You'll notice we have this foil layer still.
We kind of have to loosen it a little bit first,
and it should pop right out.
We've got our really nice flat pavé.
Now we need to unmold it.
Easiest way to do this is to flip it over.
I'm torching it here.
My goal is to just release it from the sides of the pan.
I'm not trying to warm up the entire pavé.
And then we'll test it, see if it lifts off,
and there it is.
It came out pretty clean, and it's still cold,
which is really important.
So we can go right into portioning this.
We need to transfer it to our cutting board.
There is a good layer of parchment here.
Make sure we get rid of it.
And as far as portioning, first we're going to trim it.
So we want to get it nice and square.
All right, so that's all for trim.
We're ready to portion.
Having like a half inch to three quarter inch thickness
is a good ballpark range.
Down the middle, we're just going to go in half again.
Now these are pretty big chunks,
but this would be the max size that I would go.
And you could even go in half like this
so you get like squares.
Choose your own adventure, up to you.
And these will be a little bit more crispy
compared to creamy.
If I wanted to go even smaller,
I'll break this into thirds.
And there's your amuse-bouche.
So these have all been portioned.
They're cut, they're nice, they're ready to fry.
All right, so our oil is heated to 350 degrees.
We're ready to fry.
Just slide them right in.
You could also use like your spider
and drop them in gently.
I'm looking for them to not stick to each other.
So I am giving a slight bit of agitation.
After enough cooking, it will release.
I just want to make sure
that they're separated from each other.
Might be able to tell here,
but these two guys are attached at the hip a little bit.
So I'm just going to jostle them free.
We're looking for golden brown, crispy on the outside.
At the same time, we're still looking
for that creamy interior, that creamy texture.
These are getting real close.
These bubbles are also getting a little bit finer.
That tells me that things are getting a little bit lighter
and more crunchy.
I'm happy with the level of browning throughout.
It's very uniform.
It's very beautiful.
Let's just pull them.
So drain them decently well in the wok.
We'll transfer over.
Those are our fried big portions.
Really happy with the look of them.
Some kosher salt.
I'm just going to go over the top
and then we'll give these a flip.
Sprinkle on high.
It's fried up beautifully.
I'd be really happy with this.
So here are our finished fried pavés.
At this point, you have a multitude of serving options.
We went super classic here.
I'm just going to dress this as I would in a restaurant.
If I'm at the table,
give it a nice dollop of creme fraiche,
maybe a little bit of this nice paddlefish caviar,
some fancy chives.
That's pretty ridiculous.
You can really taste through all the layers.
I mean, it's so good, I had to take a second bite.
And it's really interesting to me
because if you eat it this way, crosswise,
you get one texture.
If you eat it perpendicular to all the layers,
you get a different texture.
Really crispy on the outside,
creamy, fluffy on the inside,
bursting with potato flavor.
This is an amazing expression of a fried potato,
in my opinion, and worth the time and effort.
And just as a reference, we can cut into one of these
and we'll show you cross-section.
With this cross-section, you can clearly see
all these layers are still preserved really well.
It's nice and tender and creamy on the inside.
And that's potato pavé, a tater tot on steroids.
Subscribe to our channel and visit ChefSteps.com
for more tips, recipes, guides, and tools
to help you level up in the kitchen.
