Adding flaps to your RC plane

Flap Fliers
1 follower
1 Video View·Jan 6, 2025
Hey guys, it's Don. I'm bringing you a flap modification video
I'm doing this on Hobby King's Decathlon. This is just a basic above wing trainer
Similar to a J3 Cub or you know Cessna type plane
So flaps in general if you're not quite sure what they do
It's designed to increase the lift of the wing so really good for
For taking off in a short distance and also coming in for slow speed approaches
So by increasing the lift of the wing you you can decrease your your plane speed without having a tip stall tendency
So with with adding flaps, it's a really fun cool way to get an extra channel
on your plane and
It's really basic. There's not a whole lot to it if you've done any scratch builds
This would be obviously very simple
But what you're seeing here is I kind of map out and cut out my my flap surfaces
And you want to be careful that you're not going to be you know cutting too far too deep into any
Anything that's going to matter so you don't want your flaps to go down and bang into your fuselage
So make sure you check your clearances before you cut them. I use CA glue hinges on this. It's a lightweight plane
It doesn't require any any real heavy-duty hinges CA glue hinges tend to work very well as long as you don't
Install them in properly just make sure that you cut your your slots and have them fairly snug and use
On this plane. It's EPS. So use the proper glue
This would take a foam safe glue an EPO plane would not require a foam safe CA glue
But you can see I buried the the control arm in the foam cut out any paint any surface area that that glue won't stick
to bury the control arm in there a little bit and then glue that down cut out a surface area for your
Servos and and link them basically there's not not a whole lot to it. Make sure you've got some
some good push rod material that you can put Z bends in and you always need some kind of easy connector or some kind of
threading at the end so you can adjust the throw but
One thing to note is in general. I would recommend if you're going to be doing this modification. You should have a
Programmable transmitter. I'm using to be a spectrum DX 6i
So I actually had to turn on mixes and
And you can adjust the throw rates and stuff and one thing I had to do with this plane is when I put the flaps
Down testing out for the first couple flights. It would it would pitch the plane up a couple degrees
So what you do is with the computerized transmitter you mix in down elevators. So when I was flipping the
Throw for for my flaps, it would actually give it a couple degrees down elevator to compensate. That's great
So just make sure you have a computerized transmitter
If you don't feel free to try this you have an extra channel available a gear channel or something
You just need to remember that if you're going to be using a Y splitter
Which you'll probably have to do that. The servos are oriented in the way that they both move the same direction
So you'll have to flip one servo around you can also go into the servo and rewire it
So I hope you guys enjoyed the video. Thanks for taking a look and
Have a great day
