Oxen blacksmith with red hot molded horseshoes and their placement on a traditional lathe

Traditional Metal Crafting
21 followers
Well, we are going to add coal from Berezo to heat these irons that we are making, to make a horseshoe, a calo.
While Ángel is in charge of facilitating the combustion by adding oxygen with the fire,
Franco, the blacksmith, puts coal from Brezo in the forge to feed the fire.
Because it is the strongest for the forge, the other coal is very weak and it is not worth it.
This coal has a lot of strength, from Berezo, many calories.
We are going to spread this rod to make a calo to make a buey.
After heating a bar of iron to the red alive, the blacksmith and his assistant
beat it rhythmically to stretch it.
Well, it has already cooled down, we are going to put it in the forge.
Every time the iron cools down, it must be reintroduced into the fire
until it becomes rustic and can continue with the stretching.
Well, we are going to finish spreading it to eat the width to make the calo.
Well, we already have the spread done, now we will give it the shape.
Well, we are going to heat it, we cut it, we make it the shape of the calo.
We are going to cut it to make the calo.
Holding the piece with the tenaza, Franco takes advantage of the ductility of the iron
and hammers the calo or saw to give it the definitive shape.
Now that we have made the calo, we are going to make the holes to hold the calo, the nail,
with its corresponding holes, four holes, to hold the calo well.
Well, this is the matter.
Well, the calo is already finished, now to place it as soon as the time comes.
The calo has been prepared to be placed in the nail of a ox.
The same blacksmith did the functions of a blacksmith and his work was developed in the pottery.
Well, we are going to make a mistake, a ox, of the authentic Serrana breed that remains a bit,
but in the end you have to save it so that it goes to work in the mountains to rest.
The first thing to do is put the ox in the pottery
and sink it with a spout, make sure that it is well sunk, of course,
because no one likes to have nails, then,
well, it is suffered and you have to do it well.
They are turned around the hole so that it is well held, make sure that it is well sunk.
Fortunately, in the mill of Bilbiestre del Pinar,
the original pottery has been preserved, which is a set of wood where the ox is sunk to make a mistake.
This mechanism has a lathe with some chains and a noose,
which serve to suspend the animal from the ground.
The leg is raised because you have to make a mistake with your hand,
so that it has two legs suspended, so that it does not hit.
So that it does not hit us.
So that it does not hit us, because it can kick us.
Well, now we are going to raise our hand to make a mistake.
Now we take the cord, right?
Yes, we take the cord, we raise our hand.
To put a horn on it.
Now we are going to remove the helmet, with the lever,
to remove the helmet, to settle the horn.
This tool is called a lever.
It has to be very sharp so that it cuts this helmet,
so that later we can sit the horn in the plane we make.
Now I leave the lever and take the hammer and the horn.
Now we are going to bend it to make a good seat here.
The nails are also made of iron, a special iron,
so that they have resistance so that they do not bend.
With a guide that they have in front, which is the one that tells you where the nail has to go,
so that it comes out, if it does not get inside.
Well, now with the pliers we cut the nail to rivet it.
Well, now that we have removed this horn, we are going to start with the one inside.
We take the lever forward, loosen it a little, Félix.
Loosen, loosen, Félix, loosen.
Well, now we will put the horn here, we will rivet it.
Now it only remains to release the ox from the pressure of the straps,
chains and ropes that had it fixed to the potter,
to carry out the work of the field or the extraction of wood in the forest.
When the oxen worked in the mountains, the saws lasted about a month and a half,
but when they developed their activity on stone or asphalt soil,
at 20 days they had to be renewed by the roosters.
Men, animals and vegetation have lived together throughout history.
Man has been able to achieve performance, both due to the strength of the animals
and to the wealth contained in the plants that surrounded them,
to carry out productive activities that today have been relegated to a corner of our memories.
I am Eugenio Monesma, director and producer of the documentary you have just seen.
If you liked it, I encourage you to subscribe by activating the notifications from the bell
and so you can enjoy the hundreds of documentaries that I already have on the channel
and of which I will be uploading weekly.
