Making a Victorian Walking Skirt with Limited Fabric: Less than 2 Meters

Pre-modern Women's Fashion
183 followers
116 Video ViewsยทNov 20, 2024
Do you have a fabric stash? Well if you are somewhat like me you have one and usually don't
use any of those fabrics. Often they just don't quite fit the project at hand but I made it a
point to use some of the fabrics I own and make some garments out of it before I allow myself to
buy something new. The problem is that most of the fabrics I own are swatches. Some have decent size
but most are less than a square meter big. They were made during my internships as a textile
designer and usually they are thrown away after a collection is finished. Some of the swatches were
gifted to me so that they wouldn't end up in the trash but since then I've never came around using
them. So here we are with a fabric of 1.4 meter by 1.6 meter and my idea to make a victorian or
With the additional restriction of having as few sewing lines as possible so I won't disrupt the
pattern too much. Sounds somewhat impossible, right? Well it felt like it is. Since no pattern
seemed to fit onto the fabric the hem was just way too wide at all patterns I already had printed.
So I went on and searched the book authentic victorian fashion patterns for a skirt pattern
which fulfills my requirements and I actually found one. The description says that it is a
pattern from 1893 and I like the sketch which goes along with the pattern. The pattern had a width of
153 centimeter and therefore I thought I have with 140 centimeter width just a little less gathering
at the waist as required. Turned out I was wrong but more on that later. First I started cutting
the fabric into two pieces with a slight dip on the front of the waist so that the skirt is a
little shorter at the front than at the back. This way I used almost the entire fabric and together
with a big pocket and the waistband I had no material left. First I marked a few points of
the pattern on the fabric and then cut those pieces out. The pattern basically consists of the front
of the skirt, the back of the skirt, a pocket and the underlap. Then I sewed the pocket together.
I finally found some talatern and added it to the inside of the hem with a little patching
since the talatern is not as wide as the main fabric. I basically sewed those two pieces of
talatern with a running stitch together which is quite loose but still holds it in place.
Then I basted the talatern onto the main fabric so that it won't move while I sew the lining onto it.
Then I covered it with a white popolene so the scratchy talatern would be covered.
This lining or popolene I also basted into place before I sewed it on.
Unfortunately I realized once it was sewn in that the main fabric is somewhat transparent
and the white lining is visible. I didn't like the optic of this and decided to take the partial
lining out again and line the entire skirt. This time with a white wool since it is lightweight
in comparison to the popolene. It is really astonishing to me how a work of six hours
can be undone in barely five minutes. I haven't figured out yet if that is an advantage since
remaking something where the undoing would take also five hours or so seems really nerve-wracking.
I continued with sewing on the talatern to the main fabric with a stitch that isn't visible
at the front and then basted the entire lining onto the main fabric covering the talatern.
This way everything stays in place securely. After basting the lining to the main fabric I
sewed the two pieces together. First I basted the side seams together with a white running stitch
and then sewed it with the sewing machine.
I really got used to my old iron mamsal and I barely use my modern sewing machine anymore.
Then I prepared sewing it together, cutting the edges and basically blocking it into shape.
Then I basted it into place again and afterwards sewed it on with the sewing machine.
Once this was done I continued with the pocket and sewed it together with the princess seam.
Then I ironed the seam lines open and flat and also blocked it.
I had completely forgotten that the pocket needed an opening so I had to reopen it
and set in the pocket. Then I continued felling down the seam allowance and also sewing in
the pockets in this step. Then I lined the waistband and secured the seam allowance of
the waistline. I know that antique garments were sometimes not finished but the fabrics were woven
way denser since the shuttle weaving machines used can push the yarns tightly together and
the modern air jet or rapier looms are not able to do so. Therefore were the fabrics back then less
prone to fraying while my fabric is fraying quite badly. With the seam allowance secured I gathered
the waist with two seam lines with fairly wide stitches which I then pulled in. And this was the
moment I got really confused since the material would just not fit into the waistband. Even with
the tightest gathering it wasn't possible. So I went back to read the pattern description again
and one particular part I have apparently ignored quote the skirt is draft by the waist measure is
in one piece. I honestly don't understand it since then the width would have been half of the one I
used and I wouldn't be able to work on such a tubular and restricting skirt. So probably I'm
missing the necessary information or how to use the patterns properly but it wouldn't help in my
current situation anymore. So I decided to take the excess material and fold it in a big double
box pleat at the back and try to distribute the gathering at the front with a little less material.
I was still wondering about the instructions and I found another skirt with the exact same
measurements but a slightly different sketch and this one corresponds more with the actual product
I got. I sewed on the waistband with the sewing machine. I was quite surprised that the gathering
wasn't that problematic with the sewing machine. In fact it was easier than doing it by hand.
Even the big box pleat was no problem. Then I cut the hem even because some parts were a little bit
too long. I went on and hemmed the skirt. I made sure to just pick up the lining so that the seam
would not be visible on the front. And the skirt was finished. I'm still not sure if I like that
much gathering at the waistline and the train seems somewhat long since I have already destroyed
the hem by wearing it once. So I bought a brush bit despite the fact that the color doesn't
entirely match the skirt. Nevertheless I secured it with a quick and dirty basting stitch so that
I can take it off once it is worn out. Hopefully it will protect the hem otherwise I will have to
shorten it. So the skirt is finished so it's proof you can make a victorian walking skirt with less
than two meters of fabric. Okay main fabric I didn't count the lining. There is only one thing
left. I will make a girdle to hide a little of the gathering at the waist. I want it more
accentuated just as it is done in the sketches but this will be another project.
