Chapters: 00:00 - Introduction to Recording Sound for Film 01:06 - Recap from Episode 1 01:44 - Recording Sound on Set 06:48 - Recording Interior Sound 10:54 - Recording Exterior Sound 14:04 - Takeaways
─────────────────────
PROFESSIONAL SOUND RECORDING FOR FILM
So you're making a movie. This probably means you'll need sound. For beginning filmmakers, sound can mistakenly be an afterthought, a task to give a generous friend. But recording great sound is vital to the success of a movie, whether it be a no-budget short or a blockbuster movie. In this episode of The Shot List, we look at how a production sound mixer operates on set to get the best audio possible.
HOW TO RECORD SOUND FOR FILM
The production sound mixer works closely with the director and other departments to ensure that the audio quality matches the visual production. This means often being present on tech scouts and being vocal about any potential sound issues that may arrise. The job requires a keen ear, technical expertise, and the ability to adapt to various on-set challenges, such as background noise or difficult acoustic environments. The production sound mixer typically uses high-quality microphones, a mixing console, and recording devices to capture the sound directly during filming.
INTERIOR FILM SET SOUND RECORDING
Interiors often present challenges such as echoes, reverb, or unwanted noise from HVAC systems. To mitigate these issues, sound mixers may use directional microphones like shotgun mics to focus on the audio source while minimizing ambient noise. Placing sound blankets or foam around the set can help absorb excess sound, creating a cleaner recording environment. Boom operators need to carefully position microphones to capture clear dialogue without picking up noise from the set. Often, lav microphones might be used to ensure consistent audio quality.
HOW TO RECORD SOUND FOR EXTERIORS
Recording sound outdoors introduces a different set of challenges, such as wind, traffic, and other environmental noises. To combat these (and other) issues, sound mixers often use windshields or “dead cats” on microphones to reduce wind noise. Directional microphones are once again crucial in exterior settings to isolate dialogue from background noise. Planning is key when recording outside—choosing the right time of day or scouting quieter locations can significantly improve sound quality.
Sound is one-half of a movie. That can often be easy to forget– but a great filmmaker always keeps that in mind. Save money in the budget for a sound pro.
♬ SONGS USED: "War Paint" - Rhythm Scott "Origin" - David A. Molina "A Moon Walk (Instrumental)" - Yehezkel Raz "Double Espresso" - Francesco D'Andrea "British News Team" - Lance Conrad "1986" - Angel Salazar "Still Need Syndrome" - Yarin Primak "In Love with Emi" - Fabien Fustinoni "To Burn" - Man With Roses "Life's Journey Begins" - idokay "All Star" - ANBR "Merge" - Theatre of Delays "New World" - Ian Post "Dojo Tradition (Instrumental)" - In This World "Divider" - Chris Zabriskie "Animātiō" - Mike Steele "Inquisitions" - Kevin Graham
Looking for a project management platform for your filmmaking? StudioBinder is an intuitive project management solution for video creatives; create shooting schedules, breakdowns, production calendars, shot lists, storyboards, call sheets and more.
Ladies and gentlemen, start your engines.
Films are made up of sequences.
Sequences are made up of scenes.
And scenes are made up of shots.
In previous episodes, we discussed composition, animation and production sound.
In this episode, we will delve deeper into the sound recording process.
Can I have some quiet on the set?
Roll sound.
This is episode 17 of The Shot List.
Production Sound Part 2.
Before sound speeds, don't forget to subscribe to StudioBinder
and enable notifications to stay up to date on all our videos.
Now, quiet on set.
Well, hello, Colin.
Motherf***er!
Last time we looked at the physics of sound,
which is defined as a disturbance that creates an acoustic wave
through an elastic medium, like a liquid, gas or solid.
We also looked at various terms that recur in the sound department,
along with a plethora of equipment that is needed.
And finally, we went through the various production sound positions
that are available on set.
Today, we'll look closer at what the sound crew does on set
and how they adapt to different environments.
Let's begin with the general rules for recording sound on set.
The sound department's work on set starts long before the recorder starts rolling.
Though a sound mixer was likely present during the tech scout for locations,
they will begin to look for potential noise issues that could arise on set.
If they spot anything, they will communicate them to the locations department.
The team will also watch rehearsals in order to get a better sense of how to mic the scene.
Cheers!
It's far more than my wages amount to.
Ideally, they will be able to position the shotgun
so that it's no more than three feet away from a subject.
They can also add plant mics,
microphones that are hidden on set to capture the sounds that the shotgun may miss.
Here's the mic, right here in the bush.
Yeah!
Now you talk towards it.
Once more, it is the mixer's job to vocalize
if they see a potential sound issue during the run-through.
In the long run, vocalizing problems early will help expedite the shooting process,
an important quality for a good sound department.
Mixer Chris Howland explains.
The last thing you can do is slow the train down.
And so you're always listening to, gauging the tone of the room,
trying to read between the lines.
Because if things change, you need to be able to change with them.
And, you know, you can't rely on somebody to just tell you,
this is what's going to happen.
When actors are done with hair and makeup,
the mixer will then wire them, placing the Larv in their costumes.
It's important for a mixer to be sensitive during the process,
clearly communicating where they will locate the Larv.
It's also critical that the Larv's placement will have minimal clothing noise.
Production sound mixer Tom Williams explains his approach.
You're trying to get it right to the edge of a costume
when you've only got a millimeter or so to play with.
You really need to push it out as much as possible to get as much air on the mic.
And it still has to obviously be hidden.
Once the actors are mic'd and the boom operator is in place,
the sound department is ready to record.
The second assistant camera will slate in front of the camera
after the sound mixer confirms they are speeding.
Ensuring that the post team will be able to sync footage and audio easily.
The boom op will usually move the shotgun close to the slate to get the clap.
And then move it back into position.
When they are ready, they will often announce, boom set.
While recording the scene, the mixer will watch the levels.
They will usually want to keep audio peaks between minus 6 and minus 12 dB.
Hitting 0 dB could cause distortion.
To ensure distortion doesn't occur, some sound mixers will use limiters.
This will prevent peaks, but may eliminate dynamism from dialogue.
So it's typically used sparingly.
The sound department will also want to capture room tone.
Audio of the set without any other noise.
This recording can be used by the post-production sound team
in the sound bed of a scene.
So there's never total silence.
And so cuts between dialogue aren't as jarring.
"- You remind me of the daughter they took away from me."
A sound mixer will often remind the assistant director
at the beginning of the day that they'll need time for room tone.
"- Hold it! Hold it! Hold it!"
"- What?"
"- I still have to record room tone?"
"- Okay. Okay. All right."
When recording the boom operator will make sure the microphone
is pointed in the same direction it was during the scene
to ensure a maximum level of continuity.
"- Mic's in position."
"- Scene six. Room tone. Rolling."
Typically, a room tone recording should be about two minutes.
A sound department may also record wild takes after a scene is finished.
These are certain sounds from a scene that may be hard to recreate in post,
but which are also difficult to capture during the scene.
This could be the sound of a prop.
Or even a short line of dialogue.
Of course, sound recording differs based on the location.
Let's look at best practices for recording interior sound.
Usually, recording indoors means a recordist has more command
over the sound around them.
Interior spaces typically have controllable noise,
which refers to any noise that can be mitigated
by the sound or locations department.
This could be the hum of a refrigerator
or an HVAC system in a larger building.
The crew can often coordinate with the owners of the space
to turn off or turn down these noises.
The size of the set will play a role in what microphone a mixer may choose.
As a general rule, shotguns with fewer ports,
the ridges on the side of the microphone, are better for small spaces.
For larger spaces, more ports are ideal.
This is because ports are used to capture sound
coming from the side of a shotgun and cancel it out using phasing,
where a sound wave cancels out a specific frequency.
Too many ports in too small a space may create an unwanted phase effect,
since the subject's noise may hit the ports as well, due to reverb.
Reverb is an important consideration for indoor settings.
Short for reverberation,
the term refers to the persistence of sound after it is created.
Reverb is often most prevalent when a subject is surrounded by hard surfaces,
which will bounce sound waves rather than absorb them.
A sound mixer typically will want to reduce reverb on set as much as possible.
Even if a scene may need reverb in the end.
"- Where is Harvey Dent?"
That is usually added by sound designers in post,
so that they may have more control over how it is employed.
"- Where is Harvey Dent?"
To avoid reverb, a sound mixer will try and cover as much of the set as possible
in soft materials that will absorb sound.
They may coordinate with the art department to build carpets or curtains into a set.
But if that's not possible, they will employ furnies.
Short for furniture pads, these are blankets made for dampening reverb.
Sometimes, however, reverb and echo can be utilized deliberately.
Mixer Amanda Beggs explains her approach for a warehouse concert scene
in Mike Mills' 20th Century Women.
"- When we test scouted it, it was an echo chamber.
And I pointed out that it was going to sound like an echo chamber,
even with bodies, the band was going to have a certain sound.
But Mike was all about that.
Mike did not want it to sound like we were recording this band in a studio.
He wanted it to be the space."
Another tricky but common interior space is the car.
When recording in a vehicle, sound mixers have numerous unwanted noises to contend with
and a limited space in which to hide mics.
A rule of thumb most mixers employ in cars
is to have the microphone pointed away from the engine
so that they can avoid that noise as much as possible.
Often, mixers will hide laughs in a car's visors.
Sound mixer Stéphane Boucher explains furthering this technique for Lucy.
"- The idea was the sun visor.
And I was thinking, what about buy a new sun visor,
exactly the same one.
And then I'm going to destroy it, open it, put a mic inside,
close it again and put it in the car.
No, this is not possible, lady.
This is a police car.
Okay, okay."
Recording for interior locations requires ingenuity.
And so does recording exterior sound.
Often recording outside means having far less command
over the sounds making their way onto the set.
These sounds are called uncontrollable noises
and can include anything from a plane flying overhead
to a gust of wind.
If an outdoor set is near a roadway,
traffic sounds will also be a concern.
Sometimes this is a controllable noise through ITC
or intermittent traffic control,
where the locations department halts the traffic
when a take is in progress.
Wind is harder to halt.
To avoid wind noise,
a recordist will usually employ a blimp or a dead cat.
A dead cat is a furry covering for a shotgun
that cuts down wind from hitting the mic.
A blimp is another covering that protects a microphone even more.
But the more protection provided by a covering,
the more the high frequencies risk getting reduced.
So a mixer will typically only use the amount of protection
that is absolutely necessary.
Wind and other uncontrollable noises can also be mitigated
through smart mic placement.
On a particularly gusty day,
a boom operator may record from below an actor,
pointing the shotgun up at them
and avoiding the worst of the wind.
This is also true if a production is happening on a roof.
If there is traffic noise from below,
pointing the shotgun upwards will avoid it.
A low-cut filter can also be employed
to reduce the bass-heavy interference from wind
or low hums from machinery.
"- Hi there.
How you doing?"
Recording outside can also require contending with the elements.
In these instances,
it's important to pay attention to how the equipment is faring.
Sound mixer Mark Ulano explains the steps he took
when working in the bitter cold for the hateful eight.
"- You have to have a lot of redundancy
because things will fail
and you have to be very aware of the impact.
If you work something in the cold,
a piece of electronic gear,
and then you bring it to a warm place,
there's going to be condensation inside.
So it's like a little rainstorm in your electronics
that are designed to make it stop working
at the worst possible moment.
So you don't do that.
You have a set of cold things,
you have a set of warm things."
The elements can make their own noise too.
When dealing with rain,
a mixer may use hog's hair,
fabric which can dampen the sound of droplets.
There is only so much a sound team can do
for especially difficult settings.
The goal is to get usable sound
even if it's not perfect.
Sound is one half of a movie.
So don't skimp when it comes to capturing it on set.
Listen to your sound mixer.
Otherwise, you may pay for it in post-production,
which we'll get into on our next episode,
Post-Production Sound.
Good sound starts with good planning.
Get ahead of any audio surprises
by using StudioBinder's pre-production software.
And take a look at the StudioBinder Academy channel
for filmmaker interviews and in-depth tutorials
on creating shot lists, production documents, and more.
Until next time, keep your ears open.
What's that noise?
The mic's picking up her heartbeat.
Swell.
Ah!