Repairing a Detached Rail on a Liquid Shredder SUP | Sweep Talk 396 | Live Mic SUP

SUP Techniques
34 followers
What is up, YouTube?
Welcome back to the show.
It is not a normal day.
Obviously, we're not on the beach.
Today is repair day.
The orange is once again damaged.
This is repair job number two.
This thing is four years old.
So it's, you know, going to start coming apart.
This is a liquid shredder, vinyl coated soft top.
It's basically a closed cell phone soft top with an aluminum stringer down the middle.
I'm sorry, dual aluminum stringers down the middle.
And it's coated in vinyl wrapping.
Each one of these is its own little patch of vinyl.
They're held together with glue.
You can get glue from the manufacturer or you can use this right here, HH-66.
I had to drive up to Pasadena, Texas to get this stuff.
It's pool repair cement.
Anyway, what's happened here on mine is the rail has come off.
I had the same thing happen on the other side.
That was repair number one.
Obviously, you start by taping.
I like to tape all the way over the seam.
It may be hard to see here, but this other side is exactly like this.
I've taped it down with masking tape all the way down to the orange vinyl so the glue doesn't
interrupt the seam.
That makes future repairs easier.
Tape every single bit, top and bottom.
I don't know if you can see down there, but we've got everything taped and ready, and
so it's time to get started.
Let's go.
And the very first thing you need to do, obviously, is clean off the old glue.
Now, you can kind of see it here, little white streaks that, you know, it's probably put
on with some special tools, so they've got a nice, thin, even coat.
So, it's actually pretty easy to buff out of there.
I'm using nail polish remover.
My ex-girlfriend left this here, and I've been using it to clean glue away ever since.
Preferably, you'd want some pure acetone.
This has got perfumes and stuff in it, but oh well, it worked on the last job, so let's
get started.
And now that the cleaning's done, we can get to the gluing.
Now, as I was cleaning, I realized that it was weak all the way through, up to about
right here, about an inch and a half, an inch or so, more like two inches, I'm not sure.
Anyway, right here, it's going to be a little bit of a drippage problem.
I have it taped all the way to the edge.
To be careful when you run tape over it.
Now, I did forget to tape the rails earlier.
You want to put tape everywhere that you don't want this glue to be.
This is the stuff to use, HH-66.
Mentioned it before.
You'll want to go to the industrial section of your city, where the contractors shop,
and you'll probably find this stuff.
Anywhere where there's vinyl pool repair equipment, you will find this stuff.
And so, it goes on easily.
It's one part, which is nice.
And now I'm going to start with the thinnest part here.
Thinnest section.
Now, this glue can get out of hand.
You've got to really tap the sides.
Here we go.
Work it deep.
Now, the next step is to tape this thing up.
So, you want to start at the small end.
Work that adhesive out to the edge.
You want to get some long strips.
God, I've got a runaway string of glue.
Don't know where it started from.
You want to keep in mind, you've got to get underneath your board.
So, if you have it on a table like I do, you want to go ahead and pull it out.
You don't want to waste a lot of tape.
You get a bad pull.
It gets spiraled.
You don't have time.
And, you're going to get glue all over everything.
