Agate Teapot

Making ceramics and glass
106 followers
In this film I'm going to recreate an 18th century agateware teapot in the V&A's collection.
Agateware uses different colored clays to create a pattern that imitates agate stone.
This particular type of laid agateware has to be press molded to maintain the pattern
of the marbleized clay. To make the molds it's necessary to investigate how the original model
used for the molds was formed. My initial assumption is that it was sculpted to imitate
a shell. I'll start by measuring the V&A's piece and increasing the scale taking account
of the eventual shrinkage of the clay through drying and firing. I'm throwing a thick shape
that can be marked carved and modeled into the main body of the teapot. I'll do the same for
all the additional parts. The lid, the serpent spout, the dolphin handle, and the finial in the
shape of a Chinese foo doll. The teapot has an oval form so a leaf is cut out of the base and
the sides are pushed together. I'm experimenting with how the form might have been originally made.
After looking closely at the form of the original teapot it seems that it may have been molded
directly from a natural shell rather than being modeled. Following that insight I'm cutting my
thrown model in half to press into a mold from a natural shell. The shape, the size, and the number
of lobes on the natural shell are very close to what I need for the teapot. I'm marking the cast
shell with a compass so I can model it to recreate the exact shape I need. I've made plaster molds
for each section of the teapot. Ornamental relief on the lid and the finial is carved directly into
the plaster mold. A slab of colored clays needs to be created to press into the mold. This requires
four different earthenwares. A manganese clay, a cobalt clay, and iron clay are layered with white
earthenware to create the alternating layers. The layered slabs are turned into rolls and cut.
The rolls are then assembled alternating the colors and pounding into a solid block of clay.
The block is sliced into layers and pressed into a thick slab between two sheets of paper to protect
the patterning. A rolling pin is used to thin the slab. Based on my research it became clear that
the pattern slab of clay was sliced and then the slices alternated to create a new pattern.
I'm carefully pressing the pattern slab into the shell teapot mold and trimming away the excess.
I'm repeating that for the other parts. The edges are scored in preparation for joining
the two halves of the mold together. A tool is used to seal the seams on the interior.
Now that the clay is leather hard I'm removing it from the mold.
I'm going to clean the seams and assemble the sections to make the teapot.
The clay is rolled into a tapered coil to make the handle. The handle has additional embellishment.
An incised plaster sprig mold is used to create the eyes of the dolphin. A brass roulette makes
the pattern on the dolphin's back. I'm piercing the holes that will let the tea flow from the body
of the teapot into the spout. I'll now leave the pot to dry before bisque firing. After the bisque
firing the teapot is dipped in glaze which temporarily covers the pattern and reveals
the form of the shell. When the glaze firing is complete the final colors are revealed.
Here you can see my teapot on the right with the 18th century Staffordshire original on the left.
