
戴娜的繽紛世界
559粉絲
We are going to sew the back of the pillow
The side of the pillow is quite long
It's about 26cm
The bottom of the pillow is about 34cm
It's quite long
So we are going to use a longer thread
It's about 2.5 times longer
or even 3 times longer
Let's start sewing
We are going to start sewing from the side
We are going to sew the stitches
from the back of the fabric
It's going to be fixed here
So we are going to sew it like this
Because the fabric of the pillow is longer
We are going to use a longer thread
We can sew more stitches
to avoid the fabric from moving
Because the bag is short
So we will sew the stitches of the back of the fabric
So much stitches
A little bit shorter
It's easy to sew back
Continue sewing
We are going to sew the stitches
from the back of the fabric
Continue sewing
Compile them
We can use a needle or a pin to secure the seam
Be careful not to stab the needle
As soon as the needle comes out, turn it over
Let me show you again
As soon as the needle comes out
Turn it over as soon as the needle comes out
Now we need to push the needle out of the sides
Two small stitches mean one big stitch
For example, one small stitch
As soon as the needle comes out, turn it over
Push the needle out of the sides
Two small stitches means one big stitch
Push the needle out of the sides
The seam allowance is 0.3-0.5cm
Once you start sewing, you need to turn the fabric inside out
Turn the fabric inside out
Sew along the seam allowance
Once you start sewing,
you need to start from a incision at the bottom
Since there's only one incision at the top,
you'll start from a single incision at the bottom
The bottom will overlap
Because it's two single incisions
Start at the bottom like this
Two single incisions,
one, two, and start from the top
只要一出針,就要倒回來入針 As soon as the needle comes out, you have to turn it over and put it back in.
這個方面我記得很好,再一次 This part I remember very well, I'll do it again.
這樣子 Like this
好,只要一出針,就要倒回來入針 As soon as the needle comes out, you have to turn it over and put it back in.
這就是回針縫 This is the return stitch.
那這樣的話就不會有那個孔洞,不會像那個平針縫,它就一上一下,它是虛線 In this way, there won't be any holes, it won't be like the flat stitch, it's just one up and one down, it's a virtual line.
那這個你看,倒回來入針,只要一出針就要倒回來入針 As soon as the needle comes out, you have to turn it over and put it back in.
因為它這邊有一個孔縫隙,就是要倒回來入針 Because it has a hole here, you have to turn it over and put it back in.
那入針之後呢,在底部就是兩小步出針,底部是會重疊的,會有一小段重疊 After the needle comes in, there are two small stitches at the bottom. The bottom will overlap, there will be a small section of overlap.
兩小步出針就等於大步了,那這樣子只要一出針,我們就維持那個孔縫大概0.3到0.5公分左右,不要太大 If you make two small stitches, it's equivalent to one large stitch. As long as you make one stitch, we'll keep the hole at about 0.3 to 0.5 centimeters, not too big.
如果太大的話呢,也會容易有裂開,容易裂開 If it's too big, it's easy to crack.
好,這樣子把它慢慢的縫,只要一出針,就是在這個上面這邊一出針,就要怎麼樣,這邊有個孔縫隙嘛,就要倒回來入針 As soon as the needle comes out, it's on the top here, there's a hole here, you have to turn it over and put it back in.
填滿這個縫隙,填滿這個孔洞,這個縫要填滿,然後只要一路針在底部入針嘛,應該是說從上面往布的下層入針,從上面往下入針,只要一路針在布的底部的兩小步出針,兩小步出針,就這樣一直類推,這就是回針縫,這樣子兩小步出針,就一大步,然後只要一出針,
就要倒回來入針,就要倒回來入針,這樣看一下,就這樣就不會有孔縫隙了,就是要倒回來入針,只要一出針就要倒回來入針,填滿這個縫隙,填滿這個孔洞,然後底部會有重疊的部分,底部呢就是兩小步出針,好,這就是回針縫,
它是針縫就是這樣不會有縫隙,就是一針接一針的,因為是倒回來入針,然後入針之後呢在布的底下兩小步出針,就是一大步出針,這樣就是很密了,好,一樣的,在上面一樣,我們這樣子只要一出針,只要一出針,
