衝撃映像...恐怖の無人列車大暴走と破壊の限界!壮絶な鉄道事故2選

セカビタ 発見伝
9 フォロワー
2 回視聴·2023/11/27
応援コメ、ご評価ご登録(通知🔔オン)が大変励みになります😃
104人を乗せた失踪列車が、44年後に再び出現!恐るべき鉄道都市伝説8選
https://youtu.be/NMIMQWHnHXY
キルドーザー事件:コマツのブルドーザーを装甲戦車に改造して怒りの大暴走!復讐男の辛すぎる動機と心の叫び!
https://youtu.be/igJe0IXwlik
消息不明機が92体の骸骨を乗せ、35年後に再び出現!恐るべき航空事故3選
https://youtu.be/t6uv8b7ztgo
偶然通りかかった貨物船が、海の真ん中で戦慄の発見!驚くべき漂流物10選
https://youtu.be/opkPvSSskMI
Do you know the movie Unstoppable from 2010?
It's a story about a freight train loaded with toxic substances that loses its driver and keeps running aimlessly.
This movie is based on the CSX-8888 crash model, which I will introduce in the future.
So if you haven't seen it yet, please be careful.
On May 15, 2001, a locomotive driver was holding a SD40-2 electric diesel locomotive 88888888, also known as the Crazy 8,
and was switching 47 cars from the starting line to the departure line.
As he was switching cars, the locomotive driver noticed that the direction of the point in front was wrong.
The train was moving slowly, and the air brake was activated, but it couldn't stop at the point.
The metal 35-year-old veteran locomotive driver jumped off the train before the locomotive reached the point,
switched points, and tried to return to the driver's seat.
The speed of the locomotive at this time was about 13 km.
In addition to the air brake, the locomotive driver applied the electric power brake to the maximum and jumped off the locomotive.
But he was mistaken.
In fact, the power mode was not switched to the electric brake,
and the control lever became a full throttle, not a full brake.
The locomotive started accelerating at full power while it was in a daze.
He was in a hurry to get on the locomotive, but his hands were wet from the rain and he couldn't get up well.
In the end, he was dragged about 24 meters from his hands to let go of his hands, but he was hit by a small scratch.
The locomotive had an air brake on it, but the brake hose was not connected to the lower car because it was being replaced,
and only the locomotive had the brake on, so he couldn't stop the accelerating train.
Also, the locomotive was equipped with a device called an alerter to stop the train urgently,
but it didn't work because it was in an air brake.
For this reason, on the same day, at 12.35 pm, a locomotive with a maximum speed of about 113 km and a maximum output of 3,000 hp
started a major outage due to a load of 3,000 tons and a load of 47 trucks.
The locomotive was reported to the police by radio, informing the conductor and the train conductor of the outage.
The other locomotive driver, who received a call from the control room without knowing that the locomotive was at full throttle,
tried to get on the front locomotive, but the speed was too fast.
When he received this call for the first time, the control room noticed the seriousness of the situation.
The locomotive was loaded with 20,000 liters of phenol, which was like a monster,
in addition to materials and materials.
However, when heated and mixed with air, it was feared to become explosive mixed gas.
In Kenton, Ohio, which is about 106 km away, there is a steep downhill curve,
and in order to pass safely, you need to slow down below 40 km.
In addition, fuel storage, gas tanks, and houses were crowded around.
By the time the train arrived, it was certain that the Crazy-8, which accelerated, would overtake at a speed of over 100 km per hour and take off on a steep curve,
and if the train was not stopped before that, there was almost no doubt that it would be the third time that 15,000 people would be involved in Kenton.
At the point of 80 km to the steep curve of Kenton at 13 o'clock,
the police proposed a bold idea to shoot the emergency stop switch of the locomotive and stop the train.
The fire on the fuel tank was concerned, but eventually it was put out.
At 1.30 p.m., two police officers fired a shotgun from a close distance.
However, the emergency stop switch was only 3 cm wide and small,
and the speed of the train was already 70 km, which accelerated more than expected, and it failed.
Five minutes later, the locomotive driver, who was ahead of the other switching points,
tried to get the train out of the way and stop it at a safe place where there were no people around,
but the point was bounced back at an excessive speed of 80 km.
This also failed.
At 30 km to the steep curve of Kenton, evacuation guidance began in the city.
At this time, the media also flew helicopters and started reporting on the train.
At 2.45 p.m., an order was issued to evacuate to the evacuation line to avoid a head-on collision with the freight train Q96,
which was on its way from the opposite direction of the main line, just like Crazy Eight.
This train was ridden by a 28-year-old metal engineer and his partner.
As instructed, they entered the evacuation line and soon Eight passed through the side main line.
There, the engineer cut off the Q96 locomotive, backed up the main line,
and suggested a plan to connect the locomotive to the rear of the train and stop it by braking.
This is how the pursuit of the Q96, which became the last line of request, began.
In the evacuation line, the Q96 could not change direction and was moving backwards,
so the conductor had a radio in the rear of the locomotive.
The Q96, which started chasing while changing at 100 km per hour,
caught up to the steep curve of Kenton in the remaining 7 minutes.
However, if the speed is lowered, there is a risk of being pulled away,
so try to connect at the same speed.
Normally, the train is connected at a speed of about 10 km per hour,
but this time it was done at a speed close to 10 times that,
so there was a risk of the connector being damaged or the conductor being hit by the train,
but the Q96 was successfully connected.
The engineer used a generator brake, and Crazy Eight slowed down.
When the speed dropped to 18 km per hour,
another locomotive, which was in the lead, got on board,
returned the throttle of Crazy Eight, and stopped the engine.
The Q96, which noticed this, used the brake,
and at 14.30, the train stopped completely at Ohio City,
about 106 km away from the site of the accident.
There were only 2 km left until the steep curve where the evacuation line was ensured.
The maximum speed was 110 km, and the total distance traveled was 105.6 km,
which was about a 2-hour rampage,
and all the brakes on the wheels were burned out.
Fortunately, there were no casualties from this accident,
and there were no casualties other than the veteran locomotive driver who fell and sustained minor injuries when the accident occurred.
The metal 35-year-old man was released,
and his whereabouts were not revealed, and it is not known what happened after that.
In addition, several railroad museums tried to buy Crazy Eight,
but CSX refused to sell it because they did not think it was worth saving.
As a company, I'm sure you thought it was a good idea for our company's locomotives
to be in the railroad history books forever.
After that, in 2016, Crazy Eight was remodeled,
given a new registration number and a chance to change its name,
and is still in operation.
Don't overdo it anymore.
What a creepy picture this is.
This was taken in Ohio, U.S.A. in 1943,
when a steam locomotive accident occurred.
But what happened to this locomotive?
What happened to the locomotive that had collapsed so far?
Before that, let me explain the basic mechanism of a steam locomotive.
The locomotive engine uses fire to heat the water in the boiler,
generating high-pressure steam to move the wheels.
For this purpose, the operator uses firewood and coal to maintain the fire.
The heat and smoke from the fire
pass through several chimneys to the chimney and are expelled from the chimney.
The surroundings of the chimney are filled with water,
which becomes the boiler.
When the heat passes through the chimney,
the water in the boiler is heated and some of it turns into steam,
which passes through the steam dome and is sent to the piston,
which is the driving force of the locomotive.
However, the intense heat and pressure
puts a lot of pressure on the engine,
and many parts need to be replaced regularly.
If one of these parts breaks down,
a tremendous amount of energy is released,
causing massive damage.
So, going back to the picture,
this is a locomotive called Chirico C & Ohio T1K No. 3020.
In May 1943, the residents of Chirico C
heard a terrible roar coming from this railroad.
Apparently, the noise came from a train parked on the railroad tracks.
The engine was terribly deformed,
and the debris of steam scattered all over the place.
The three passengers on board were badly burned,
and all of them died.
Apparently, the boiler exploded,
and the front of the locomotive was blown away.
When the train was passing by,
Vincent and his wife, who lived nearby,
heard a loud explosion.
The explosion was so violent
that if the wife was using a machine,
she would flip over on the desk.
The master, who saw the scene,
knew that another train was coming to the east,
so he ran about 1.5 km on the railroad tracks
to avoid being blown away by the debris.
The exact cause of the boiler explosion is unknown,
but at the time of the accident,
the train was running uphill,
and it was thought that it was decelerating
just before it stopped.
The staff at Chirico C
didn't want to go uphill,
so they assumed that the water in the boiler
was reduced.
If they added water at this point,
the engine would cool down,
and there was a risk of it going out of control.
However, water is essential for steam locomotives,
and it is also used to make steam.
When the boiler heats the water,
the water cools the boiler.
In other words, if there is a shortage of water,
the temperature can't be adjusted,
and the metal plate of the boiler
heats up too much and the metal starts to melt.
This mechanism produces high-pressure steam
that can run several tons of trains,
so if a part of it breaks down,
the steam will explode
and leak out.
It seems that the brakes and the locomotive drivers
were blown away by the heat
and drowned in the heat,
and they died of burns.
The locomotive driver,
who lost his sight,
also reported that
he was in a coma
and poured water into the boiler
just before he was injured.
In the old days,
locomotives didn't have
a lot of water,
so they monitored the water
and maintained it.
At that time, the boiler explosion
was mainly due to a shortage of water,
but the explosion so far is rare.
Even now, 80 years later,
this photo has a disturbing impact
and reminds us
that it leads to a major accident
with a slight misjudgment.
I don't know if they died instantly,
but I can't help but hope
that they had a peaceful end.
