Phục Hồi Lại Chiếc Đèn Bão Xưa Nhiều Rỉ Sét và Hư Hỏng

Hello everyone, today I would like to show you how to make a flamethrower It can be very noisy, but today I will restore it Because it has a lot of damage Let's see if I can restore it This is baking soda Flour used to make cakes I use 2 tablespoons of baking soda to pour into a plastic container Then I use glutinous rice vinegar to pour in Create a clear mixture Use this mixture to pour over the entire flamethrower Let it soak in the reset I soak for 30 minutes So that the reset is completely soaked Then I will wash it with clean water After washing, some parts are also exposed And easy to remove First we will remove the bar to hold the light Then I will remove the light bulb Then I draw the smoke tube of the flamethrower And proceed to remove There is a spring in the smoke tube The spring is reset so it sticks to the light The smoke tube is also partially damaged Here, the eyes cover the smoke tube Then we continue to remove the adjustment part of the light bulb After removing the parts We continue to prepare a plastic bottle Hold the reset And continue to soak the entire flamethrower and equipment Have been removed into the reset I continue to soak with this reset Pour the entire reset into the flamethrower And soak for more than 6 hours While waiting for the flamethrower to soak, we go to clean the light bulb The light bulb, after being cleaned with soap, will look very bright and beautiful The light bulb of Germany Then we go to dry the light bulb Then we come back and bring the entire flamethrower to clean One last reset I use a pot to clean the reset After cleaning, I will dry it After drying, I still see that the light bulb still has a lot of spots There are some hard lines that cannot be separated I use a machine to clean it In the places of contact between the two parts The reset part is also very much After cleaning, the light bulb cover is damaged So I use a drill to drill a hole for the light bulb Then there is a piece of paper to cover the hole Then use glue to create a new light bulb cover After applying glue to the cover, remove the cover from the light bulb Then I will glue the damaged cover to create a new light bulb cover So we will have a new light bulb cover I use PVA glue to glue the part that is loose at the bottom of the light bulb Then I use a piece of thin rubber that is cut from a cotton swab Then I continue to apply glue to the position of the light bulb cover Then I use sandpaper to sand the cover to make the light bulb more beautiful In the places of contact with the fire, I use heat to melt the sandpaper I cut the cover of the cotton swab to make the cover of the light bulb I use PVA glue and 3 small pieces of sandpaper to glue the cover of the cotton swab Then I will apply 3 pieces of sandpaper to the cotton swab cover I continue to glue the spring to the tube to install the light bulb The light bulb after being painted looks very new and beautiful I continue to adjust the light bulb Continue to put the light bulb in Then I put the smoke mask on the half side of the stave I will test it The light bulb was increasingly beautiful a lot more than when I was on the island. In the evening when I light the candles, I will remember the old memories, the place where I used to hang the lanterns. At that time, I didn't have a flashlight, so I learned from these lanterns. It was a beautiful memory for me.