DIY: Replace Weed Eater or Trimmer Line

TightWadDIY
899 followers
1 Video View·Jun 16, 2015
This video demonstrates the best way to install new trimmer line or string to your Weed Eater or Trimmer. Most trimmers with the bump feed option have the same type of head seen here. Auto feed trimmers may be slightly different but the same concepts apply.
Welcome back guys. This is the tightwad and today we are working on
adding new
String to the weed eater or trimmer as some people call it
First thing you have to do is remove the cap. So this one just unscrews. So I just turn this piece
until it comes off and
The string spool just lifts right off of it. I always check for markings on it
It'll tell you which way to wind this one says to wind line
Clockwise and then you need to look on the inside
For a way to lock the tip of the string in so if you see the little holes
Inside each side there you stick your string in there and then you can wind it from that point
The top of it has ways to lock the string
Once you're finished winding you lock the tip in here
So that it's easier to feed back into the cap of the weed eater
Once you're done and you need to find the one that matches the size, so we're using
The string we have is point zero nine five
so I find the
point zero nine five markings and
That's where we'll finish with our string and there should be one on the opposite side as well
All right, so I take the tip of my string and I stick it in this hole
Stick it in as far as it'll go
goes in about half quarter inch to a half an inch in and
Then I wind it tightly and remember
Goes clockwise, so I want it tightly in
this direction
You try to wind I try to wind it on one side and then the other of that groove
And you just keep filling it up until it's full
Till it meets up almost to the center
divider
All right, and I don't want to put too much on there because you don't want it to pop off
So you got to stop at one of those sections that says point zero nine five and then you just pull it into the notch
And that holds it tight and in place
All right
Repeat the same process on the other side. So stick it in the hole
Make sure you get it all the way down in there
Then I'm gonna wind it clockwise again
Kind of going one side to the other and then you're gonna end up opposite of the first line
Stick it in the notch
Take your cutter. This is the cutter that came with the trimmer string this cutter failed several times
So I suggest you just cut it with a pair of scissors or you can use pruning shears
So you have a spring on the back and this is a bump style trimmer
It feeds every time you bump it on the ground
So when you bump it the spring compresses and this turns and it releases a little more string
So to put it in you have your two strings and there's two holes on the head
so you go ahead and feed your strings in first and then you line up the spring with the shaft that's there and
Push it down
You can now pop your string
So all you do is pull on them and it pulls them out of the grooves that we're holding it in place
And then that should allow you to push the the cartridge far enough in
To screw your cap on screw your cap on securely and you are good to go
When you fire up your trimmer
If there's if the string is too long, it will automatically cut itself off on the guard. So it'll go to the correct size
If you found this video helpful, give it a thumbs up. Don't forget to subscribe for more home repair and lawn repair videos
