OMICRON’s product manager, Fabian Öttl, offers his insight into the importance of stator core measurements.
The reliable operation of rotating electrical machines, whether generators or motors, is essential for continuous power generation and critical industrial processes.
Our stator core measurement upgrade option allows you to reliably detect interlamination imperfections in the stator core of rotating electrical machines.
00:00 - Introduction 00:25 - rotating machines are composed of multiple stacked layers 00:36 - local eddy currents 00:47 - low flux measurement method 01:26 - CPC 100 acts as excitation source and measurement device 01:54 - higher usability through the semi-automatic sensor movement 02:12 - manual mode 02:23 - controlled by Primary Test Manager software PTM 02:53 - Summary: Here are 3 things to keep in mind
The reliable operation of rotating electrical machines, whether generators or motors,
is essential for continuous power generation and critical industrial processes.
However, not only defects in the electrical insulation but as well problems in the stator core can cause rotating machines to fail.
As you may know, stator cores of rotating machines are composed of multiple stacked layers,
which are insulated against each other.
This is done to minimize the eddy current losses.
A short between two or more layers lead to higher local eddy currents.
This again can lead to local hotspots, which in a worst-case scenario can even cause a complete damage of the machine.
Testing during maintenance helps to detect such weak spots.
One method is the low-flux measurement, where the stator core is excited with a few percentages of its rated flux.
An auxiliary winding is providing this excitation.
The detection of potential issues happens via a sensor, a Chettock or Rogowski coil,
which is moved along the surface of the stator core.
A higher reading in the measurement indicates a higher eddy current.
The big advantage of this method is the low power requirement compared to the excitation with rated flux.
The latter one is often difficult or even not possible to achieve, especially when it comes to larger machines.
Enough power out of an ordinary power plug in combination with a high accurate in and output
allows the CPC100 to act as both the excitation as well as the measurement device.
This gives us the possibility to test either with rated frequency, 50 or 60 Hz, or frequencies even up to 400 Hz.
Knowing that a manual measurement can be cumbersome and time-consuming,
the intention was to increase the usability as much as possible.
Therefore, a semi-automatic movement of the sensor comes with a stray flux measurement solution.
The rail enables this movement and is placed with strong magnets onto the stator core.
Additional fall arrestors ensure that the rail cannot fall once positioned and damage any devices.
For local diagnosis as well as for special cases such as long-stepped end areas of large turbo generators,
measurements in a manual mode are also possible.
Everything can be controlled by our primary test manager software, also known as PTM.
Beside an intuitive guidance throughout the test, including connection schemes,
an automated calculation of the excitation voltage is provided by the operating software.
Intuitive real-time signal display and a summary of the measurement by help of a heat map are also part of the solution.
Yeah, and the icing on the cake is the one-button report function.
So to recap, here are three things to keep in mind.
Number one, the CPC100, used together with our stator core measurement upgrade option,
provides a turnkey solution for stator core low-flux measurements.
Number two, a semi-automated sensor movement improves the usability
and ensures time-saving electromagnetic imperfection testing.
And number three, everything can be controlled by our PTM.
This includes guidance through the test, intuitive results analysis by help of plots and heat map, and simple reporting.
For further information, please visit us on our website.
I'm Fabian Oettl, product manager at Omicron Electronics. Thanks for watching.